Search results

I have had my used B2710 for a few months now, and the only thing that I haven't liked was a small hydraulic drip coming from the HST case. Initially I thought I had just over filled the resevoir, and there was some overflow dribbling out somewhere. But it persisted, and so I stated to look...

RPMS are stuck at 0 Does anyone have a schematic or some tips that can help me trace the tachometer wiring? What sort of sender does it use? I assume it is electrical. All the rest of the electrics are working OK, so I doubt it is a fuse. Thanks, Al

It\'s snowing here too Just so no one thinks we are missing out, here is a shot of Mauna Kea, Hawaii, taken from Maui, about 25 miles away across the channel. Sorry for the poor quality, but my little camera is not much for long shots. Anyway, at the top of the mountain you will see the snow...

Here is a simple electronics project that I use to keep my various batteries from getting sulfated over the course of a winter. Works better than a trickle charger alone. Many people have been successful with it. Note: this is not a commercial link, and I make no $$ from it. Just a homebrewer...

When I first got my B2710 from the shipper, it would start up with no reluctance. There was fuel in the tank from So. Cal, where it was purchased. Now that I have put some local fuel in the tank and changed the oil/filter, it is reluctant to start, ie it starts then dies a couple of times, the...

On my B2710, the 3PH control lever only has an effect in the top half of its range; ie, from 0-4, no effect, from 4-8 the hitch goes from all the way down to all the way up. Is this normal? Otherwise, the system seems to work fine. I bought the tractor used, and so don't know if this is...

I have been working with my new Bailey's/GME 6" PTO chipper,and thought a slight modifiction would be helpful. The feed rate for the hydraulic brush dragger is OK for the softer or small stuff, but it needs to feed a bit slower on the bigger hardwoods that we have. I wonder what is the best way...