Search results

I have the Kink Kutter XB for my BX-25. I couldn't find any info in the owners manual concerning oil change intervals for the top and side gear box. does this fluid ever need to be changed? I don't think I could find what type of oil either. Thanks.

Trying out the KK tiller. so far so good. tilled and back- dragged the back yard.

perhaps someone here can explain the following: after using the Bx-25 for 6 hours tilling my back yard I parked it then checked the tranny fluid the next day. I noticed when I pulled the dipstick out that there was dust down in the neck of the fill area beyound the dipstick. how is red clay...

I received a letter from Kubota stating that they will no longer be offering the revolving credit. I suppose they took a beating on it in this economy.

I purchased a new King Kutter XB-48 tiller for my BX-25. When I got the tiller home I noticed it had a small problem/defect. I called King kutter and they promptly had a rep drive down from tennessee to personally deliver a replacement unit to me here in GA. I would say it would be pretty tough...

should I be running an "over running" PTO clutch adapter on my rear PTO on my BX-25 for tilling or does it have an internal one, or does it need it at all? :confused: thanks in advance

New Mahindra Max 28XL Walkaround - YouTube

For your viewing pleasure.....:p

This was witout a doubt a very capable little tractor.

I'm curious and I dont have the manual for the deck. I can see the front latch and the lift arms need to come off but what about the shaft, where and how does it disconnect? I figured I ask here to streamline the operation :laughing:

After I'm done installing my sprinkler system using my back hoe I plan to remove it and install my 3PH so I can run my King Kutter XB tiller. Is the 3PH hard to install? anything special I may need to know? special tools, etc.. Thanks in advance.

I've been told 2 ways of properly checking the fluid level in the axle on the BX-25. one was to fully insert plug beyond the O-ring and the other was to just let the O-ring suspend the dip stick above the opening. Does anyone know the proper way. My axle was a little over a quart low. I went...

As a new member I'm looking forward to a little tractor dialogue. I've owned everything from a Deere 3120 (hated it) GT-235 - X-575 - Kubota L-2800 / KX-91 excavator for the Plumbing biz, BX-22 - BX-1830 - and now a BX-25. there appears to be no shortage of topics here.:thumbsup: