Search results

I just seen that you posted this about two years ago. Did you ever figure out your problem? The reason i'm asking is i have a ford 660 tractor also and have had problems with my power steering leaking and replaced that gasket also several times to no luck much in stopping the leak. It might...

I had to jump my ford 6600 off because the battery was dead, it cranked and i run it about 5 minutes then i had to cut it off and do something. When I came back to jump the tractor off again i couldnt jump it off with battery cables hooked to another vehicle and it wouldnt crank after...

It’s not clogging the baler, and I don’t think it is to dry

it is mixed grass hay with Johnson grass hay, I usually let it lay about 24hrs before I bale it. I usually bake it at 570 pto speed or higher. The grass is thick and the windrow are usually as wide as the mouth of the baler. About 10 bales per acre

I have a vermeer 5400 rebel baler and when i bale hay with it hay piles up on top the belts and i have to get off the tractor and clean the belts off about every 10 belts or so. If not if will cause the belts to track wrong. Any ideas why this is doing this and how to fix it?

i need a diagram that shows the different seals and o rings placements for a ford 6600 2wd tractor. If anyone has one I would really appreciate it

I have a Vermeer 5400 rebel hay baler and when the bale the half the size it痴 suppose to be the looks like the belts are slipping and the chains are making a noise. Can稚 seem to tell if a bearing is going bad or if maybe the chain or sprockets need chaining. I can turn my pro on off several...

I have husqvarna lawn mower with 27hp engine, oil started leaking from behind oil filter. So i was going to mow my yard before i started to work on it. Thought it might just be filter was loose tighten the filter a litter but still leaking oil. Still leaking oil, looks like right behind filter...

I have Massey ferguson 135 tractor that I was bush hogging with the other day and i backing up a hill raising and lower the bushing as i was backing up the hill then went to put it forward gear i lowered it and now it wont come up. I have had this tractor awhile so i thought i would drain the...

vermeer 5400 rebel clogs sometimes and makes a racket. Noticed the pto gearbox is leaking oil around the seal. can somewhere tell me where i can add gear oil to the gearbox. Sometimes i can cycle the pto and it will stop making a noise or dump the bale out and it stops making a noise...

I have got a Husqvarna lawn mower with a 27 horsepower kohler engine that is leaking oil from the valve cover. I put a new o ring in it and put permatek sealant on it but it still leaks. Does anybody have any suggestions on what i can do to stop it from leaking

I have a 135 massey ferguson tractor that I use to put out hay. I used it last week to put out hay and it worked fined but it has been extremely cold this week and I went to put out hay today and the lift would not pick up the bale of hay or lift without anything on the hay spear. Can somebody...

Does anybody have any ideas how much it would cost to replace the clutch on a ford 6600 tractor? Parts and labor

How to do I change the bale size on a Vermeer 5400 rebel round baler with electric tie? I put the computer in learning mode and made the bale bigger but I don't know how to save to remember that size every time. If anybody has the answer to this I would really appreciate this

How do you remove the injector pump on Massey ferguson 245 tractor

How do you remove fuel tank on ford 6600 tractor and how hard is it

The baler won't start the tying cycle on its on. You have to get off the tractor and trip the lever on the baler. Anybody have any solutions to this problems

How do you check or change fuel injectors in ford 6600 tractor. Also how do you also adjust the clutch on the ford 6600 tractor

New Holland 650 baler not tripping to tie on bale when suppose to. Even made bale smaller by adjusting baler but still make big bale when tgis happens there is a high pitch noise you hear. It also lugs the tractor down at this time. Does anybody anybody anysolutions or ideas as to why this...

When I am bush hogging thick grass or briars the bush hog seems to slip or quit cutting till I raise it or get in thinner grass. Is that the clutch or could that be the bushhog itself?

How hard is it to change a starter roll on a New Holland 650 Round hay baler?

What could be the cause of a New holland 650 Round hay baler to clog up when you just start a new bale sometimes? Once you get it started good you can go as fast you want. Usaully start off in 2 low and it still clogs up. Anybody got any solutions as to why this does this?

Can some tell exactly how to wire a mf 135 diesel tractor that has a alternator with two wires coming out of it. The wires burned into a couple of weeks ago and me and My dad tried wired it up and the battery won't charge. We put a new ammeter on it that came from tractor supply. Thought it...