Search results

I have a 2004 CK20 HST/TLB. It has about 2800 hours on it, it was bought new.

My CK20 H TLB, is 18 years old with about 2700 hrs on it. It's still being used on a regular basis with no problems except the hydraulic pump, I'm on my third.

Mine stopped locking in place many years ago, I use a bungee to hold it in the on position. There's a small spring loaded ball that is supposed to lock the lever in place and it's housing is plastic failed on me a year or two after I bought my 2005 ck20.

All linkages are good, lots of oil, drive shaft turns and the hydraulic lift works. Since this happened I was able to push the machine into the garage just like it was in neutral, never could do that before, any ideas?

Just got a snow blower for my CK20, it has hydraulic rotater and hydraulic deflector, question is can I use my rear BH remotes to power a valve for these cylinders and still have my 3pth operate.

I have a G1700 Diesel, lately the engine shakes badly, I think its fuel so I changed both filters and it ran better for about an hour now were back to the shake. It seems to get worse as the tank gets low on fuel, I have used additive for water etc and can't see any dirt in the tank. Any ideas...

could someone please check their new model CK20 suspension seat for me. I need to know the manufacturer, seat model and dimensions, W x D etc. thanks in advance Ray.

Has anyone installed an aftermarket suspension seat on the older CK20, I'm looking for a reasonably priced replacement, which one did you use and how do you like it Thanks Ray

I have an 04 CK20 TLB Hydro, it came new with oversized rear tires, they run very close to the fenders. My question is could these tires cause any problems with the transmission gearing etc. especially in 4 wheel drive. On my last oil change there was quite a bit of metal on the mag plug and...

I was going to buy a HST filter for my CK20 the dealer wanted $77.95Cdn for it, is this price normal, are there aftermarket filters available etc.(part #s) also what should I expect to pay for a hyd. filter. Thanks in advance Ray.

I have to dig beside an existing foundation for sealing. I will be using a mini backhoe (CK20HST) and wondering what is the best way to tackle this job, dig parrallel to wall or at 90 degrees etc . Your help is appreciated.

I have a CK20 with a 54" bucket, does anyone know what the capacity of that bucket is e.g. .5 yard, .75 etc.

Bringing it home in the fog http://

Just ordered my new CK20, thanks to this board for helping me make this decision. I was leaning towards the BX23 but after reading the comments on this board decided to go with Kioti, cheaper and much more tractor. I will be using this machine in a light excavating/snow removal /lawn maintenance...