Search results

Hello - I'm sure this topic has been hashed out a hundred times, but need to ask. I'm looking for our would like a loader for my 8n... for light duty work. I want a small loader and really like the look of the Paulson loaders. However, looks like they are out of business? I'd like live hydro...

Has anybody used suitcase weights on a ford 8n, 9n 2n? Wondering if they are available? Im mowing some trails in my woods that get a little steep and would feel more comfortable with some weight up front.

Hi All- this is rookie question. My 8n lifts and lowers great in when the system is in "Position Control". However, when I flip the lever to "draft control" my plow will drop to the ground and the lift will not lift it anymore. I've done some reading and understand how the draft control works...

My 8n lift will go up and down nicely with no implements on it. I just attached a 6' woods mower and now find out it will lift fine, but sticks and when I try to lower it. If I wait awhile, it will eventually let loose and slam down. I think it's a sticky exhaust valve on the hyd system? if...

I have a question on my N idle speed. It's a late 1950 side mount distributor - I have a new carb (marvel), new wiring, distributor cap, rotor, coil, plugs, wires, and even pertronix electronic ignition. My N will start fine, but I cant get it to idle below 800 RPM. I''m following the new...

Ok so I replaced the inner and outer seals on my 1950 8n. I found out my hubs were worn so I replaced those too. I've done the axle pre load with the shims according to the FO manual so the hubs turn in opposite directions. What I'm not clear on is how tight or how hard should it be to turn...

OK, so anybody have any tips on how to get the 4 screws out of the rear break drums so I can pull them off? Wow are they stuck - almost have to drill them out? but want to check before doing so.

Hi All, i'm new on the site - first post. Been reading a few threads and am amazed at the knowledge out here. So I have a late 1950 8n (my first tractor) and I'm in the throws of rebuilding it. I discovered the front axle bearings were shot, as well as the spindle bushings and thrust bearings...

Hi All, i'm new on the site - first post. Been reading a few threads and am amazed at the knowledge out here. So I have a late 1950 8n (my first tractor) and I'm in the throws of rebuilding it. I discovered the front axle bearings were shot, as well as the spindle bushings and thrust...