Search results

Hope this is the correct forum.... I acquired a 2017 Haulotte Model 4527A boom lift from private sale in 2019 with about 200 hours. It is in excellent condition and I am happy with it, except for the boom pins and wear pads. There are no grease fittings on the boom pins or means to lubricate the...

I have been reading through postings regarding leaking front axle seals and there quite a few. I replaced both front seals on my 2003 L3130 March of 2013 (both were leaking and leaving 3-4" spots on the floor. March of 2017 the RF seal had started to leak and was replaced. Last week the LF seal...

Hello everyone. Been a while since I have been on. Life has been overcome by events. Picked up a 2005 Kubota RTV 900 diesel with 300 hours in a local sale couple of weeks ago. Nice little machine. Biggest complaint is being thrown through the windshield when my foot slipped off the accelerator...

Have L3130 HST with 1200+ hours on it. Been extremely satisfied with it since new. Have issue with three point hitch after complete fluid and filter change. Hitch will not go up until engine rpm is 2500+ rpm. Then it's slow. UDT is within the dipstick marks. With the service, I changed the...

Had an occasion to use my pto generator due to a power outage a few days ago. Sounds like a bearing was failing in the brush end. It is an old Niagara Power (Generac), dual 7500 watt power heads for 15,000 watt capacity. Rated for 115/230 volts, 60 cycles at 3600 rpm (540 rpm pto speed). In...

Have a question on a Troy Bilt Cultivator. It is a 4 cycle gas tiller that has been blowing the crankcase and valve cover seals. Found that the crankcase vent was plugged by the crank seal assembly. Of course it is out of warranty... Finally purchased a new crank assembly and am reassembling...

I noticed an oil leak on the RF wheel this week while using my 3130 moving logs (might of overloaded it with the LA723 loader). I bought the tractor new and tend to push it when working it (isn't that what it's for?). It has 560 hours on the clock. For those that have replaced the front axle...

I just obtained a bil-jax, model 16000, 49 foot, boom lift (1987 OMME). It is in good shape, but needs a little tlc. When I put a gauge on noisy hydraulics, the pressure pegged my 3000# gauge. Was able to find the main pressure control valve and reduce the pressure to around 1000#'s. Bil-jax...

Has anyone else had problems with the King Kutter 60" idler pulley bearings? I have had to replace most of the bearings/idler pulleys in about 40 operating hours a couple of times. The last set is about a year old and I lost one bearing yesterday. This mower is about four years old. With the...

I picked up a Niagara PTO alternator at a farm auction last week. It is a dual powerhead, 15,000 watt unit and seems to work very well. Ran it today under 30 to 50 amp load (240v) for an hour or so. Looking for a manual or wiring diagram. Anyone have experience with this unit. Is alternator...