Search results

The front hub seal, LVA14181, cost $42 from deere , it’s Dana part number S20HH106, $9 from drivetrainamerica.com

We only use MFWD when needed, the wobbling was due to no preload on the taper roller bearings.

attached my write up for rebuilding the final drives on a JD 4720

The washer was broken to pieces along with the factory 0.065" shim, allowed the bearings to have no preload, axle moved destroying the seal, oil leaked out.

The washer, nut, gear is the final drive. It's just out board of the plug you replaced.

I must be the only one to have this issue.

I have a JD 4720, noticed the left front wheel was leaking real bad. Found the hub was moving up and down, which destroyed the seal before any other damage could occur. After pulling off the hubs I found Left side hardened washed in pieces sitting in the gear area, Right side hardened washer is...

I recently purchased a Shaver SC 50, time for new teeth. Any reading material I can find says it takes the 2 7/8" teeth, mine measure 2 1/2". Is it just mine?

Update, I had given up for the night, driving the tractor to the barn I noticed the arms lifting at normal speed, hooked up the 1200 lbs stump grinder, lifted it as normal. Best guess is air got in the system, i found another person who lost hydraulic fluid and had to cycle the arms about 10...

Update, I has given up for the night, driving the tractor to the barn I noticed the arms lifting at nirmal speed Its the lever with the numbers that is used to control the height of the 3ph arms. What's the correct name? The brush hog is 3ph.

I have a 2006 JD 3530, Power Beyond, FEL, BH, Grapple. This morning I lifted the brush hog, set it where I wanted to leave it and removed it. Hooked up to the 3 point stump grinder that I've used a few times with this tractor, hopped on, moved the draft lever, it didn't lift the grinder. The...

Labrat, I see you're in Central Ny, grew up in Rochester, now living in Erie, PA. I see an old thread about you installing a CV Joint in the snow blower drive shaft. Can you share more information on part numbers and what was required?

I apologize if this has been covered, I searched and could not find this info. Does any one have a NAPA or other manufacturer part number for JD Universal Joint Part Number M802832? Needing to replace both my MFWD front drive shaft U Joints. TIA

Thanks for the responses, the T2A is a weldment secured by a roll pin. I see my pic is grainy so it is difficult to see but the shank has been drilled on each side but not through, it appears the securing method is to peen the sides of the tooth into the shank where it was drilled. Here is...

i need a JD part number for this tooth, dealer is useless