Search results

Hi Guy,s Some how during a head gasket replacement I lost a push rod last week-end! I'm sure that beer did not play a part in the loss , but I can not find that push rod at Hoye or my local J.D. dealer.Can anyone help me? I only need one,but am willing to buy all four just in case that tractor...

Hi All, I have an old ym2200 that needs front spindle bearings,bushings and seals for both sides.Can anyone help? Thanks in advance.

After reading a previous post I'm in doubt about the amount of oil that should be in my engine.The post refered to a ym 1600 stating that many Yanmars only hold 4-5 qts.If this is true then I'm overfilling my YM2200 by at least 3 qts.It used to burn so much oil (2.0 qts. per hour) that I would...

Hi all,After a lenghty and very trying complete rebuild of my YM2200 ,I'm lost on how to set my valves.Any one know the procedure,and the clearences? Thanks Jim

Hi all, I've found everything I need ,except for the driveshaft. Danny had the input shaft,anyone have a driveshaft in good condition....anyone? Thanks,Jim

Hi all,I'm having a hard time getting the input shaft out,this is the one that couples to the drive shaft.We have the shift forks,hydraulic reservoir,front plate,and all the snap ring's off.The front bearing came off easy, and the shaft came out about 1/2 inch then stopped.Isn't that shaft...

Hi guy's.I need a driveshaft and a transmission input shaft for a Ym2200.I know they are scarce,mine is worn badly,and I hate to put it back in.Any help out there? Thanks Jim

Hi guy's In the process of re- building my engine, the machine shop called today and said the liners (sleeves) would not fit my eng.They are too long, and the lower o-ring area is too short.My parts supplier lists the Ym2200& theYm2700 as taking the same liner.Has anyone ran into this before...

Hi All, I'm doing a complete overhaul on my YM200. I have the engine cleaned , ready for new cylinders,my question is ,the liners came with two o-rings for the bottom of the cylinders,but what seals the top? Should I use a sealer or does the headgasket take care of sealing the top of the cyl...

Should the serial numbers on the engine match the numbers on the frame, trans.rear end or whatever you call it? thank`s Jim

Hi All, I`ve owned a YM2200 for 12 years, and now it`s getting sick, so I need a source for cyl. liners, pistons, rings,and gaskets.Not an issue,but the last five digits in the eng. and frame numbers do not match,are they supposed to on Yanmar? Also I have a chance to buy a YM3000, which I know...