Search results

Remember when a car was considered nearly worthless if it hit 100,000 miles and wasn't on it's second engine and transmission.

It's a matter of what you get accustomed to using. I have tried to like the Kubota pedal configuration but don't like it. I prefer TYM, RK, pedals that are side by side. Plant your heel in one spot and only slight movement with the front end of your foot.

I have the TYM264 and have been very happy. I have fel, backhoe, 5ft bush hog, and 5ft rototiller. I am sure the 264 has been discontinued even though it had a better engine than the T25 (model replacement). Major difference T25 has front hydraulic remotes, T264 it is an option. I would buy the...

TYM has backhoes for all sizes of their tractors and they come with the necessary subframe. It takes me 30 minutes to install or remove mine. Seen guys do it in 15 but I'm extra cautious. The backhoe gets less use than any of my other attachments but I don't regret having it (stays off until...

If you are buying new and haven't already, look at flail mowers.

Mice love to eat tractor electrical wiring. It's good to keep a mousetrap near your tractor that doesn't require resetting every kill. I've had good results with a homemade trap made with a pop can, a stiff metal rod, and five gallon bucket. As seen on YouTube.

In camo it's too easy to lose. Stick to Green, Orange, or Red (TYM or Mahindra).

HST makes FEL work easy. TYM has a left and right pedal so you plant your heel in one spot and never have to move it. That same F and R pedal also increases the engine speed the harder you push. Of course there is the traditional throttle hand lever and cruise control switch for sustained rpms.

Ford has said that future ICE Mustangs will be rev-able from the key fob. As though they aren't noisy enough now, owners will be revving their engine from the kitchen table over coffee. Why?

Electric vehicles actually run on coal or nuclear power, or a combination of both.

You forgot to mention what kind of chainsaw he prefers.

She hasn't had a trim since she was a flapper!

I would sell the all thread, it's so commonly used it should be easy to sell. I would use rebar, and concrete with fiberglass strands from the plant. My biggest concern would be the all thread rusting over time, expanding and cracking the concrete. If you think concrete with rebar is expensive...

And even though the Toyota is assembled in Texas, the profits all go to Japan. Thank you for supporting Japan!

Do the profits from the Texas built Toyota stay in the US? That's what I thought!

You're assuming that over the next 5 years the landscsping company will not raise their rate. Are you serious?

Before placing the safe on floor, place a piece of plastic or a heavy duty garbage bag. One man can then slide it anywhere. Hand truck is good but sliding is way safer.

You may want to consider TYM. There backhoe is made very tough, I greased mine last week and stopped counting zerks when I got to 27. On a CUT get the backhoe with the tractor, the subframe is mandatory or you can break tractor into two large pieces.

On craigslist you can find used billboard material. They cost more than tarps but are large and extremely durable. For a sawmill shed roof I'm sure you don't mind advertising for some product that is probably gone.

I hit a stump while operating a John Deere and was swarmed. Shut it down before running, they got me about 15 different spots. Left eye was completely swollen shut. They swarmed everything on tractor that was yellow, seat, badging, yellow key fob. I got the tractor back 3 days later after 6 cans...

There may be a 10 year warranty but it will be pro-rated on the battery. I would recommend you go to you tube and look at the Ford electric pickup compared to a Chevrolet conventional pickup towing lightweight camping trailers. It didn't go well for the electric. Europe is years ahead of US...

First thing. Get liability insurance that covers you off your own property. If you don't get insurance stay on your porch. Just because the potential customer is nice doesn't mean they won't sue if something goes wrong.

It's no secret. RK is built by TYM. It's labeled TYM on the data plate and even on the Rurak King brochures and flyers. Fine machine, more weight to ground, more lift capacity front and back than comparable size others. Great prices too.

RK is still being built by TYM and continues to add new models and features.

I would never remove the ROPS, Mine can be folded down. I do fold it down occasionally, but it's up 99.99999% of the time. If yours doesn't fold modify it but don't take it off.

Mouse pee isn't about being poor housekeepers. Mice pee is how they mark safe paths for each other, that's why they always travel the same paths.

You have a good point. I should have posted the dimensions as you did. But it sounds like original post indicates he will need the extension kit as I did.

You didn't state which grinder you're using. Sounds like Bauma. If using Bauma on cat 1 tractor an extension kit is required (moves grinder away from pto approximately 6 inches) otherwise shaft can't work properly. Too long when up too short when down. It mentions the kit on their website. I...

Sorry I didn't see your question until now. T264 you can tilt bucket as the arms are raising or lowering. If bucket is over filled with gravel you need to tilt bucket slightly when arms are way up, otherwise you can spill some gravel onto your hood. Hope you got a T264 they've been replaced...

If you don't have to consider frequent transport or limited storage space, get the BIGGEST tractor you can afford. No one ever says I wish I had gone smaller but a lot of users wish they had gone bigger.

Buy one from Amazon that's low height and weather resistant. With wheels straight 12 is a good spot, you won't always use it, like when driving straight long rows or driving on roadway. You'll only use it when doing tight work, cleaning stalls, clearing snow, digging, facing rearward, etc...

The Kleenex didn't harm them it just provided one of their favorite best materials. You have a serious infestation and it will get worse unless you stay on it. On YouTube are several non-poison options. I use the 5 gallon rolling log homemade trap. It catches multiple victims without...

You don't need to worry about this truck. It will be a high bid as IH trucks are popular with street rodders. These bidders aren't afraid to take on a project and are no match for uninformed skiddish truck buyers. If you would like to see some of their creations look on Pinterest. Your only...

Look on you tube at the 5 gallon bucket rolling log mouse traps. They don't have to be reset between catches They work while you sleep. The uncaptured mice will be back for more.

You use old worn crap, we'll make our own purchasing decisions.

Everyone on this website knows this is a scammer. What's the point of the overly long post? We applaud you for learning something that everyone already knows.

Few owners do this, but I like the rear view mirrors I installed on the FEL upright mount arms. They're never in the way, cost under $15. (Ebay), and mounted easy. I bought ones for Club Car cart. No matter where you are using some dumbass will walk up behind you!

Digging Graves

If you have to ask if you need a gun or a gun rack, you shouldn't have either.

You don't have to make the switch all at once. Watch the chain stores for a sale on multi tool pack with charger and batteries (20v). Pick up an inexpensive 20 to 18 adapter for the really expensive tools you own in 18 (ie large impact driver). Once you have gradually switched completely to...

Neither a borrower nor a lender be!

Yes the land plane. Built to groom driveways and dirt arenas. So easy to use and great results. I sold mine when I didn't have road to maintain any longer. Will get another if my situation changes.

I should have checked more sources. I trusted a Yahoo post by JD Power

Jeeps don't have the least depreciation by a long shot. The least depreciation is Honda then Hyundai. According to the math not my opinion.

Oops almost forgot.

I've had T264 for a year. Great machine. Lift capacities should be much higher than 254. Some are opting for the T25. Bottom line......you'll find engines vary Yanmar or Kukje. If you like the expense after warranty of JD go with the Yanmar. I like the Kukje, it a Cummings design. If you...

I cant get the TAFE site, dealer listing to work. I'm trying to find a dealer in the Louisville KY area. I'm most interested in the 2800CE If you are a dealer or know one please reply, Thanks!

Planning a Mahindra purchase later this year. Have narrowed down to 2615G or 3215G. Is the 2615G not available with shuttle shift or is it equipped but goes by another name? I hate to spend the $3000. extra for the 3215G, owners opinions would be helpful! Thanks, Garry