Search results

Last night I finally hooked a hydraulic flow meter to the remote ports on the back of my BX23 with 750 hours on it. At full throttle, it's 3.75 GPM. The only references I ever found were that the system made 5.5 GPM, but it always seemed like my hydraulic projects ran slower than expected...

Recently I've noticed that my BX23 shift/speed lever won't go all the way into high gear (rabbit). It goes about 1/3 of the lever travel and stops there. There's nothing in the way of the linkage. It also pops out of gear which is not surprising. Low range works fine. Any thoughts would be...

Does anyone happen to know the size and type (NPT, whatever) of the threaded fitting that is the return to tank on the right side of the hydrostatic? It's plugged from the factory, located behind the right rear tire. I'm working on a powerbeyond circuit that will need a separate dump to...

I'm trying to figure out how to pull some hydraulics off a dead forklift to use on my Kubota with rear remotes and was hoping I could get some help in understanding how it's plumbed. I've attached a sketch of how it's plumbed, for a visual. The forklift has a valve that raises the mast, and...