Search results

'Why do they put the filters underneath??' Right on rScotty. I saw a 4cyl Subaru Outback; lift the hood, the filter is right there; fitting side down and with a catch bowl.

Hi mark I'm thinking you don't want to be in my situation with the transmission. If you can find a really good cast iron welder you might have a chance at repairing it. My situation; two handfuls cast iron chunks on the floor. I need a transmission; can't find one. Good luck

Curved forward, well compared to the gravel bucket. The gravel bucket is small and the snow packs at the back wall. The large curve at the back to cbel the snow up and forward to allow a bigger scoop ... the bottom would be deeper as well.

Tractor Tech, thanks I went there; so far it's looking like tractors, attachments etc. I sent a request; fingers crossed. It's a great little tractor I'd rather put it back into service than ...parts tractor.

My transmission casing is shattered; all cracked up; not repairable. The tractor is fine; I need a transmission for it. Does anyone have a lead on where to start looking for a replacement? I've tried and got nowhere.

Does anybody have any lead on 'parts tractor with a good transmission'. Backing my snow blower into a snow bank, I blew up transmission cassing/totaled. I've been looking I can't find anything. This little tractor is too good to be a parts tractor. Thanks

I changed out a set of wheels on my hydrostatic NH TZ25DA. With both wheels off the ground, and the transmission in neutral. In lining up the holes to thread in the lugs I rotated the hub. When I did the other side, I rotated that wheel and noticed the opposite wheel turned the opposite...

My 'Little Blue' is a 25hp NH DZ Sub Compact. My FEL bucket is perfectly matched to hydraulic capacity for gravel; 500lbs. I am swamped with three lanes of snow plow snow banks. I have a 52" rear PTO Snow Blower but the FEL gets full plow/pick up and dump duty. I cannot find a decent 'snow...

My NH DZ25 subcompact. I have a 4' bucket and a 42" PTO snow blower. The FEL is a good match; a bucket load of A grade gravel is the max weight it can handle; then there's snow. I'm looking for a 'snow job bucket'. The wettest snow weight is less than 1/2. I have a large yard, tight quarters...

My NH DZ25 subcompact. I have a 4' bucket and a 42" PTO snow blower. The FEL is a good match; a bucket load of A grade gravel is the max weight it can handle; then there's snow. I'm looking for a 'snow job bucket'. The wettest snow weight is less than 1/2. I have a large yard, tight quarters...

Mine is a NH TZ25DA, 3cyl diesel 25 HP engine, 18 HP at the PTO. Reverse in High is practically useless powerwise, I can't back it up my trailer ramp in High. In Reverse Low it's "boil me an egg' slow. I'm looking to get a snow blower attachment for it; the front mount ones so far are costing at...

I'm at wits end searching for a front mounted snow blower for my NH TZ25DA subcompact tractor. New Holland stopped producing subcompacts. Any search leads would be appreciated. Thank You.