Search results

I have a small Kubota with FEL and a box scraper. I bought a cheap winch from Harbor Freight-mostly because of the bargain price. I have occasional need to pull small trees and bushes and a few logs from sloped areas and thought the winch would be useful, but now I can't determine any logical...

I was pleasantly suprised to find my 14' chains fit into a coffee can (all but the ends.) I used heavy bailing wire to tie the cans onto my box scraper, slip the chain ends onto the frame and off I go. I always carry two chains on the tractor because my main need is brush and limb clearing...

I have a B7100 and fairly steep acreage. I have been using the tractor in 4WD about 95% of the time to avoid slipping on the underbrush and ditches. This winter I drove to a friends about 2 miles away and found I couldn't disengage the front drive for road travel. The tractor is stored outside...

I have a small crack in the pot metal (I think-maybe aluminum) manifold. This is right at the connection for the hose. I have tried electrician tape 5 ply held with a hose clamp-no luck it bleeds air past the tape. The photo shows the black tape/clamp area. I can't find a dealer for this...

I hope this is apropriate to post here-its not finished yet. I had three channels with holes punched in them (called UNICHANNEL I think) and need a rake to clean out grass between ruts in my driveway and to clear paths thru the woods. A local dealer sells bolts and lag screws cheap by the...

I have a sloped lot and need both a garage and a shop. I want to rough sketch and estimate what this might cost me but I haven't been able to find much on google search. Has anyone done, or seen anything like this? It will be about 26' square (bigger if costs are OK) with garage level with my...

I have a small 4WD Kabota tractor (I think its 16HP) with a front bucket and a box scraper. I have two channel iron scraps about 1.5" X 8" X 30" I am considering flame-cutting the channel into 6 wedges to be welded to 1/4" X 3" X width of the bucket plate to make a lightweight portable toothbar...