Search results

We are mowing approximately 10 -14 acres with a Bad Boy 50 in. and a Scag 72 in. I have tried several commercial products to reduce under deck buildup and they were so-so. My best results has been from totally cleaning and washing the under deck and letting it completely dry. I then spray a...

I have a 5545 that is about same weight you are looking at. After spending months looking at different trailer designs and ramp combinations I settled on a 20 ft so I would have enough room to keep my hitch weight in a respectable range. I preferred slide in ramps as opposed to ramp gates. The...

Daydk1, have you found you problem? If not, you should check your Pto switch. If that switch does not engage when the Pto clutch is disengaged, you will have an open circuit to your starter switch. If all your starter/battery connections are good and you still get nothing when you try to start...

I have a 4530 and a 5545 that is almost the same as the 4530. Since you can short across the solenoid your positive battery connection is ok . My experience on both tractors is the battery negative cable. They are not the best quality even though they may look good. Since your starter and...

I have had problems on both tractors with the PTO interlock switch. On the 4530 it failed on a restart in the field with no contact with the starter. I ended up taping a piece of wood to hold the switch in until I could it back to the barn. On the 5545 I shut it off after brush cutting and...

I have a 4530 and a 5545 which are same platform with different electronics. Had same problem which was ground from battery to frame. If you can jump hot lug on starter solenoid to ground with screwdriver then positive side is good. Suggest you take both ends of your battery negative cable off...

I had very similar problem with my 2 year old 5545 where I shut off the tractor and the next time had a click and then nothing. I checked all battery connections and they were all tight. I assumed battery was low and tried to jump it with but still had a click. Removed the battery and did a load...