Search results

Welding it up shouldn’t be a problem other than preheat and cool down rates. Problem with machining what is there is the boss is hollow on the inside and to remove enough material to get back “round” I fear it may be too thin to support the load.

Good afternoon. I have a TC55DA EHSS that has a worn pivot bushing boss on the front axle housing. Has anyone had any luck welding these and machining the weld back down? Couple of questions… Is the axle housing cast iron or cast steel? I need to know some specs on the stub boss ie what is the...

I pulled the hydraulic speed control valve assembly so I could see inside and found one of the little “fingers” out of position. Pushed the plunger back so it could fall into its proper spot and now it works as it should. I did weld it back together and saved some $$

I have a TC55DA EHSS. The hand lever for the rear lift broke at the shaft arm. There was enough of the arm remaining that we contemplated a weld repair. While contemplating we attempted to rotate the shaft in the up direction to see if we could actually perform the task but the shaft WILL NOT...

I'll stop by the shop and see if they'll give me a copy of the electrical schematic. Thanks for the reply

I have cleaned all of the connections, applied dielectric grease and reassembled. This has been up until lately a very sporadic occurance but lately it is getting more frequent. Thanks for the reply

I've posted on here before about glow plug issues but now I have a new problem. I have a 2006 TC55DA/EHSS that was bought used but in like new condition back in 2008. It's been a really good little tractor but it's beginning to act like it wants to be traded off on a bigger 75 HP model (1) I...

Check the safety switch under the seat and the PTO safety. Since the glow plugs don't come sometimes, check the ignition switch too. I've checked all of the switches and the only one that isn't working is the brake switch. Should this keep the glow plugs from functioning? I don't think so...

Check the safety switch under the seat and the PTO safety. Since the glow plugs don't come sometimes, check the ignition switch too. I've checked all of the switches and the only one that isn't working is the brake switch. Should this keep the glow plugs from functioning? I don't think so...

Two issues... 2006 New Holland TC55DA w/EHSS (1)Anyone had issues with the brake safety switch not working even when bypassed? My brake safety switch when applied is supposed to allow the operator to dismount the tractor while the engine is running. It started operating sporadically and then...

Hello all, I am new to this forum and just want to take a minute and say hello to everyone and I anticipate whatever help you may be able to offer. I have owned a New Holland TC55DA EHSS for about 10 years now and have really enjoyed the tractor. I do find myself wishing at times I had a...