Search results

Your right, I had everything cleaned or replaced except the ground cause it was a pain to get to. After jumping it I discovered that it was the culprit. Now its mow mow mow. Thanks for your help

OK...I'll try jumping it. I replaced the + cable a few years ago. I'll let you know how it goes.

Did you even read my post before you replied?

790 no start. all contacts cleaned, bat charged. With ignition off I have 12+ volts to the starter. with ignition on but not trying to start I have 0 volts to starter and a click or 2 at the ignition but still have 12+volts at the bat. With ignition to the start position, I get a click and then...

I think its the clutch anyway...when I let the clutch out it rattles like the thing is falling apart, I push the pedal in just a inch or so and the noise stops. Other than that it runs fine. I can't figure out why it rattles so much when I have it all the way out or is that normal?

Not starting, a couple of clicks at the starter...now, not even that. I've checked everything I know of...Bat, fuses, safety switches, bat wires and terminals, pto, in neutral etc. I've got lights and flashers. I get nearly 14volts at the Bat and same at the starter (the Bat is near new). When...

The lower lift arm, RH side, sitting in the seat, the ball end (not draw bar end) has busted open. The lift arm has a removable ball on the tractor end and a cat II on the draw bar end. Having trouble finding a lift arm that fits over the ball end. Anybody have a part # and good source? The...

Lift arm lock washer gave way, bolt came out (all while mowing) and right lift arm fell off and thrust washer on end of lift shaft fell down in the bell housing. Removed the lift cover by taking all bolts out which left the lift cylinder assembly laying in bell housing. Fished out the thrust...

Pics tell all...good news...I have the shop manual, have tools and know how to use em...mostly:confused3: Have not done this repair before so could use advice from those who have. End nut/cap came off while mowing and limped her back to home base. What parts, aside from end cap/nut, need...

Recently acquired a 790, under the seat were two wires twisted together...assume these are for seat switch to ignition? There is also a hydraulic male connector under the seat, I'm not savvy about power beyond kits but pretty sure this is not one...so what's its function? Under the seat, not...

I have an opportunity to pick up an Alamo SMC 65A 3 point backhoe and am wondering if my 790 will handle it and whether or not it will fit. The thing barely has the paint scratched off and its been covered and stored inside. I'm not familiar with properly fitting/sizing a backhoe, or...

Recently acquired a nice 790 its a 2000 ...what a change from my old Fords. Previous owner passed recently so I don't have much info on why he replaced both lift arms on the 3pt. or why he had to weld one or why the RH adjustable one is severely bent. Looking for a good set of aftermarket...

One of the bearing housings that hold the roller busted out. Got new ones and bearings and snap rings. This looks like a pretty straight forward replacement (as long as I can get it lifted and positioned right). Have not done this before so any advice is most appreciated. Don't have a tool to...

Field is tall but I've got the cutter at the right height. Pulling 5' cutter with 9N. **** grass winds around the PTO shaft and builds up and causes strain on system. Is there a simple solution to this that I am overlooking?