Search results

I have a tc33 that has had a starter that sometimes click and will not turn over. Bought a new starter and it spins but does not engage, the bendix is not moving. Sent that one back and got another one. Same thing! Put old one back in and now that one will not engage. WTF its one connector and...

Have a tc33 and the 3pt lever is seized. Any insight, have had the tractor for 20 years and never has happened?

yes it pulls on the lever behind the axle

My 4x4 is not working all the time? When I shift into 4x4 doesn't engage? The lever is being pull back all the way. Any ideas?

They are, found them on Messick's site. Didn't see it the first time I was looking.

Are the spindles rebuildable on this deck. They want 475 for each spindle, I have play in all 3.

Took the deck off pouring out of the shaft. Has anyone taken one apart, i am assuming there is a seal around the shaft?

Have a tc 33 with a mid mount mower. It is leaking hydro fluid, has any one had a leak there? is there a seal around the shaft or is there a gasket against the housing? Can't tell were it is coming from.

I have a 60" rear Yanmar blade from I think the late 70's. Does any body know if they make a replacement. I cannot find any on line?

Have a 445 with no spark to the plugs. I read a lot about a spark delay module but I cannot locate it on this model. The parts catalog does list on for a 445. Do all 445 have this module? Or do I need ignition module?

I have a tc33 that I just replaced the head gasket. Got it started and now has a bit of a miss. Will start and run but low on power . I do have a injector that has a slight leak going to replace all of the copper washers this week. Could it be that injector sucking air or what else? I looked...

What the **** is the secret for working with the hood brace getting the rocker arm support. I got it off but pryed a lot on it. The head is loose in the front but feels connected by this brace? The manuel does not cover this at all.

I am in need of a service manual for a tc33 for a headgasket replacement. Is the only option digital? I would prefer a paper copy.

I have a 03 tc33 tractor, i try to shift to mid mound pto it grinds. there is not adjustment on the lever what is the cure?