Search results

Hello! I'm setting up my 3-point for the first time since owning my 240D. It came with a slew of 3-pt parts and I've mostly got it figured out, but, there's always a hiccup. So, I have 2 different length lift arms. One is 34" end to end and the shorter one is about 26" end to end. It barely...

This is off the tractor.

Back at it again. Any ideas how to get these roll pins out? Driving them into the housing only bottoms it out on the gear, not freeing it... I already tried that. First, second and last picture are pins before driving center pin inward. In the third picture you can see it bottoms out on the gear...

Not sure why my photos are up side down. Trying again.

Here are some pictures of the carnage... The very last pic you can see the broken off teeth at the bottom right.

Also, I tried pulling the passenger hub from the axle. It appears i'll need a puller of some sort? The splines appeared to be a little booger'd, but it's still hard to tell with all the rust. Almost looks as if the hub tried spinning on the splines in some parts.

Hello all! First post here. I'm new to tractors. A little over a year ago I acquired an early 70's YM240D with a Ford backhoe. Anyways, I was out on her this morning clearing some brush with the FEL. I was pushing a pile pretty hard in 1st, Low range, 4wd. When I lifted the front end and started...