Search results

I have a WC 8 Chinese PTO wood chipper similar to the Woodmaxx WC 8N or the Jimna. I also have the dreaded feed roll drive shaft problem where the pin type universal joint fails. Can some one suggest a technique to deal with the drive shaft compression spring when installing or removing the...

I've almost completed a brake rebuild on my !H2444. All of the linkages on the left side were rusted away. They are fairly easy to fabricate. The right side casting was full of grease/oil. At first I thought it was due to a leaky seal but upon inspection I don't see any leakage. It is a mystery...

My used IH 2444 has 18.4-16.1 tires. The rims are 8 bolt with a 6 inch center. The bolt circle appears to be 8 inches. Are there any other rims available to fit this tractor?

would like to power a conveyor from my log splitter. Can I tie into the log splitter circuit to power a hydraulic motor? The splitter valve is an open circuit, spring return. Can I plumb the motor using the open circuit return line? Will this method still be protected by the pressure relief valve?

I redently bought a 2444 with a Kubota 3pth backhoe. I operated the backhoe and tractor before I purchased it and both ran OK. When I got it home I did some digging for about an hour without any problems. Later I started to dig again and the tractor started to run rough when under load. I...

Just bought a IH 2444 that needs some work. I sent away for the IH-201manual but haven't received it yet. I'd like to change the oil. Anyone know how many quarts it will take. What grade of oil? Thanks in advance

Can anyone tell me what the minimum safe engagement is for a telescoping PTO shaft?

I would like to build a hydraulic chain saw for parting off logs for firewood. Does any one have any recommendations for specs on a hydraulic motor? i.e. Flow rate, cubic inches per revolution etc. I would assume that some where about 3500 rpm would be required. What about pump capacity?

The valve controlling the crowd cylinder on my LW-6 oozes hydraulic fluid where the spool exits the valve body. The leak occurs whenever the PTO pump is running. I am not familiar with the construction of spool valves. Is this leak repairable? What is involved? I'd appreciate any suggestions. Leigh

Attached is a photo from my 1910 manual showing the location of the auxiliary service port. The instructions say that this can be used to supply oil to an aux cylinder when the lift control lever is placed in the notch in the upper part of the quadrant. This description is pretty vague. Can this...

After reading about the utility of box blades in this forum, I bought a heavy duty 6ft BB to repair the run off damage to my woods roads caused by the recent nor'easter in NJ. Without bringing in fill from some where, it appears that filling the gulleys caused by the run off will involve...

Can anyone tell me how to increase the setting on the pressure relief valve? I believe the factory setting is only about 1000PSI as I received it