Search results

Thank you very much for the input. I have never had a pin just not give before, after heat cycling and beating it with a punch.

Hi thank you, I can’t get the old pin out. It does not move at all, and I got it hot. If I did the yoke I’d do the U joints, and it needs the plastic shield. So I’m looking at close to $200 and a few hours of work. Going to set it aside and buy a new shaft for now ready to go. it looks like...

Still can’t get it out. If that is a pin, it’s not moving at all. Should I just buy a new shaft? The safety shield crumbled as well. It’s in good shape otherwise.

Hi, I bought a used Howse bush hog. The button on the PTO was stuck in, so the shaft would just slide off the splines. I freed it up last night with a lot of heat. I believe there is a pin holding it in, but it almost looks like part of the casting. I cleaned it up with a file, but I was only...