Search results

My return line was on the diverter valve below the seat

The 261 tractors have a 2 step clutch 1st step stops the drive wheels 2nd step or all the way down shuts pto off the hydraulics run off pto drive what I did on mine was basically permanent mount a box blade on mine with a 35 gallon hydraulic tank on it with a pto pump to run loader my third...

Airbag wiring should be bright yellow and a separate circuit from everything else in the seat pics would help

There are 2 types of smoke detectors ionization and photoelectric. The ionization smoke detectors have a lifespan of 10 years, there's a radioactive piece inside that degrades over time it actually " smells " the smoke. Whereas the photoelectric " sees " the smoke particles. Ionization smokes...

What I did is pto pump from surplus center not sure what gpm a 40 gallon fuel tank I mounted on my box blade it's permanent now. Because my tractor had a lever for either hydraulics or 3point not both at same time now I have 3rd function front end loader hydraulics and 3 point at same time with...

Had a 94 crew cab with aod got 10 empty 7-8 with 12k trailer

Around here you can sort it out for them but when the truck comes it all gets dumped in the same compartment ive watched them unload at the landfill also

I have the atlas 10k extra wide version no complaints with it. My slab is 8" with fiber and mesh. Took about 4 hours to setup. Had it delivered to wife's work because they had a loading dock,it saved me couple hundred on shipping. I've had screw cab long bed with a diesel on it no problem.

Make sure you have enough clearance to be able to pull axle shaft out if need be. I put mine 5 ft off of the wall just for that reason. I also wired up an outlet and drop light off of the power coming in

Looks like you need to remove the bolt in the last picture and it should come out with some persuasive hammering

This is 1 I picked up at an auction its a land pride unit came with 8 " auger I modified a 4" auger for it works ok with the rocky soil here

Those is the motor I have on mine it is made Boland pride model hp25 I believe

Check out just a few acres farm on YouTube he uses gravity wagons for his feed for his animals . I'm not sure how far he has to go for feed though

A piece of square tubing bolted to the side of your bucket slide it over the post tilt bucket back lift up and out

If you do have a warranty issue with rigid I hope you have better luck than I did ive sent an email about my warranty issue never got a response looked up my account no tools listed in the warranty but had a battery replaced like 6 months after I bought the tools but there is no record of any...

Thanks I'll try again had a warranty issue with a battery they sent me a new one no problem but this time having issues

How did you get in contact with rigid I have tried through the website calling them put on hold for 45 minutes first time hour half second went to home depot they said to call rigid gave up went back to dewalt I have a drill and Sawzall both quit on me

You can take a propane torch to them to rejuvenate the gloss of them did it to an old four wheeler once brought it back bright green better than new looking just have to be careful with the heat and speed several youtube videos

Look up Rob Bob on YouTube he is Australian and has some neat ideas from a 55 gal barrel up to several hundred gallon containers we built one out of ibc tote some lava rock cheap 20$ pump from Amazon put a 300 gal heater in it for the fish in the winter Put about 50 small gold fish to just see...

My brother got mail from his friend after he went into the army, the letter had my mom and dad's name and the address was the dairy farm across from the airport

The transfer case is not aluminum its magnesium I did something similar it took 3 tries welding it up to stop seeping fluid

It's a built for suitcase weights