Search results

finally had a chance to check it out, reset valves, had one off, i remember getting a call when i was setting them, so i must have missed 1. no more multitasking! runs like a champ again. Thanks for all the replies.

set the valves, just winged the gasket, no knocking until you throttle up or under torque, starts really easy and runs good at full throttle with no smoke, sometimes will idle a fair amount of time without smoking. the little bit i used it it seemed to have good power once it got through the...

the head was sent in and checked out good, the water pump had gone out last summer causing the head gasket failure, could be the block? yes its a shibaura not sure on gasket thickness but will check into it. Thanks everyone.

0 it started doing it right away

I have a tc55da that I replaced the head gasket on, started right up but had excessive smoke from exhaust and a fuel knock when revving up, I replaced the injectors but still does it, mainly when needing some torque or at idle, runs and starts great other than that, never touched the pump and...

for? I put it in the lower position, but it wouldn't lift back up.

Thanks, I'll check Monday, maybe possible the pressure relief isn't going all the way back in so not building enough pressure? it seemed a hair sticky, I pulled the inching cable out but nothing obviously wrong, it needs a new cable so will order one, the head gasket is out too so lots of work...

I have a 2005 tc55da with 3200 hours that suddenly lost most hydraulic functions and won't move, loader will lift in jerks like its low on fluid, but its not, pressure relief valve for the inching clutch seemed sticky and could use new cable but I don't think that's the problem, ordered a new...