Search results

Oh and that hook under the seat is a solid hook. No It is indeed a vent pipe. Not sure for what. I took it out (it's threaded in). When i took it out, it looked like it was just a plate below it

It does have power steering. Is also a 4wd

After closer inspection, i think that the transmission and 3 point do share the same oil. The sump is connected directly to the side of the transmission. I alolso checked under the seat and therr is no obvious fill location. First image is under the seat. Second image is the sump from below...

Scratch that. Ali Express comes through again. Just outrageous shipping. :( https://www.aliexpress.us/item/2251832524457681.html?gatewayAdapt=glo2usa4itemAdapt

Is there another location to add fluid? I really don't see any other obvious location to add hydraulic fluid if it needs it. Thanks Piper! That is really useful information!. I will check it out. The seat flips up on hinges, so that may make it easier to check out.

Does anyone know if the J285T 2 cylinder diesel motor is supposed to have an exhaust manifold gasket? Had to remove it and there was no gasket between the block and the manifold. If it is supposed to have a gasket, does anyone have a good resource to find one? I have tried Circle G tractors...

As an update, after the weather got warm and the ignition switch wasn't used, it started functioning again. I do appreciate the replies to my original post

The first image shows the pipes/lines that goe to the 3point hitch (small line) and the canister (big line) the second picture is the canister. The big line goes to the bottom of the canister. They both go to the front of the tractor to what i am assuming is the hydraulic pump.

Hope to get some photos this evening.

Have a Feng Shou 184 with the 2 cylinder J285T diesel engine. Based on this document ( https://pruefberichte.dlg.org/filestorage/JIANGXI-FENG_SHOU_180_Standard-Nr1333-1991-englisch.pdf ) it looks like the transmission and hydraulic lift use the same oil. there is a canister on the right side...

How many connections are on the back side of that Switch, and yes, I meant key switch with a glow plug position.

Thanks, I have contacted Mahindra in the past when I was trying to purchase a new starter for my tractor. They don't really have much information on the Jiangxi Feng Shou tractors.

Does anyone happen to know how many leads are on the ignition switch, it is the Feng Shou 184 (maybe 284). Four wheel drive, two cylinder diesel engine. I found the following on ali express that states it is the ignition switch for the tractor. But if anyone could confirm if it only has 4...

And as far as the taryl dactal video. The guy, and other people, dress up like that to do the skits. Makes it entertaining while teaching something. The main character is a shop owner in northern Indiana.

I believe. I found a replacement here...

Took starter off tractor, hooked postive up to the postive pole one the starter, and grounded to the starter case. Got nothing from the starter. So starter is bad, correct. Next question, where can i get a new starter? Does mirhanda sell the parts?

Took starter off tractor, hooked postive up to the postive pole on the starter, and grounded to the starter case. Got nothing from the starter. So starter is bad, correct? Battery is brand new, so i know its good

Understood. But i should be able to take the solenoid off of the starter and hook a postive up to the starter pole where the solenoid connects and a ground ro the starter case and verify the starter is actually throwing the gear, correct? While i have the solenoid off I will make sure the parts...

ground is good. When i turn the key, the solenoid does kick in. But is not throwing the starter. Continuity is good on both the ground from the battery to where it is connected to the frame, and on the hit line from the battery to where it comnects to solenoid. At this point i think i am...

No, It was pretty obvious that something was amiss when the last connection to the battery started throwing a mass amount of sparks when trying to connect it. And the alternator was not working to begin with. After swapping the battery, that was the next item to be troubleshot and replaced...

I was thinking about trying this. It has worked for starters/solenoids on riding mowers in the past.

Have a 1991 Jiangxi 184-4 tractor. Battery was dead. When trying to jump it from another vehicle the wires were crossed. (i.e. pos to neg and then neg to pos, it's a long story, don't ask). Anyhow, Pretty sure the battery was smoked. Bought a new battery hooked it up and now just getting a...

Unfortunately, the belt is pretty old. It will definitely need to be replaced, the outer coding material is worn through, so it is really just a matter of time before I have to replace it

When I purchased my Jianxgi Feng Shou 184 tractor, it came with a finish mower. I believe it is also a product produced by Jiangxi. Outside of removing the belt and actually measuring it, anyone happen to know the length of this belt? It is a 60" finish mower. And do they carry these belts...

Hello, I would be very interested in the Operators maul for this tractor!

This is a Chinese Tractor. 2 Cylinder Diesel 4 wheel drive. Was wondering if anyone would have any information regarding two levers. One slides from front to back, and has a hole that sets into a nub on the slide plate. there is one nub at each end. Would this be to engage and disengage the...