Search results

Solved! Issue was a bad display module mounted on the firewall. Replaced and glow plugs work as they should.

New to me dk40se. When I got it, it did not start worth bean. Previous owner had wired in a manual glow plug switch to activate the glow plug relay. Found 3 burned out glow plugs. Replaced them. Starts good now. What I'm finding is that I get less than 1 volt to the signal wire at the glow...

Tested solenoid - it was good Replaced relay - it was good Tested key switch - it was good Issue seems to be the the power in wire to the stop solenoid relay was not getting proper voltage. Don't know why. Ran a jumper wire from the fused side of fuse 2. Working good now. Does anyone have a...

In actual fact the issue is that if the solenoid is manually pushed in, it will hold in that position with the engine running until the key is shut off. This will shut the engine off, but you will be unable to restart it until the solenoid is removed and manually pushed to the run position.

Does anyone have a good supplier for a display module part number t2185-69872 or know if it crosses to another number?

So the question is, where does the 1sec 12v signal to the pull stop solenoid wire come from? If I can figure that out I've found my problem.

Boss302 that is how this system is suppose to work. My question is do I have a failed display module (is that where the 12v pull signal originates from)?

As I understand it, when the key is put to the run position, a quick 12v signal is sent to the pull wire to retract the solenoid. I don't get 12v when I do this, only 1v or so which is not enough to retract the stop solenoid. Am I correct in this?

So the solenoid is fine. I tested it on the bench and it works fine. Issue is that I am only getting 1V to the stop solenoid pull wire. The solenoid hold wire gives 12v no problem. I swapped the starter and stop solenoid relays and it acts just the same. Any suggestions? Could the display...

My tractor is a dk40se. 1550hrs. Problem I'm having is that it will hot shut off with the key. To shut it off I have to do it manually at the solenoid. Any suggestions?