Search results

Good evening JC. Yes my pump is just a single pump like the one you have in the photos. And yes the relief valve is a little different setup as well also the plug on the right is another type of relief valve without the adjustment screw and that one had a washer and 3 shims in it. I took the...

Good morning. I do have a loader and that works perfectly fine. I had 3 point hydraulics Monday after I did a hydraulic filter clean and oil change now I have no movement at the hitch also I had no movement before the change so that’s why I checked and cleaned the filter and oil. Loader it still...

Yes correct no oil comes out of either one of those plugs I’ve removed to check for flow and no oil comes from either one. I’ll try a gauge on the pressure port but I’ve had that plug removed as well and no oil comes out. It should come out with the gauge plug removed correct?

No worries JC and yes sir I have cleaned throughly I had the plug removed and no oil coming out of the plug hole. Would the flow control valve cause the 3ph to not raise or does that just adjust the speed the hitch let’s up and down? Thanks

Good morning JC. The 2, 1/4” lines run behind the 4wd selector down the left side of the trans cover and under the dash area to a hydraulic box on the steering column I’m assuming power steering. What I’ve done so far is hydraulic oil and filter clean, new lift piston seal, took apart relief...

Good evening. I know this thread is old I’ve looked at a couple different post about this problem with Ford 1700 no 3 point hydraulics and I’m still stumped. But for whatever reason I’ve got a little different setup than most I’ve read about attached is a pic of my relief valve setup and block...