Search results

My fuel water separator was leaking. Changed it out, and tractor won’t start, like it’s getting no diesel. Is there a procedure after changing this to get fuel going? Pic of the old one changed out

Great point, I actually just watched the shutoff and noticed it wasn’t opening all the way. Problem solved. Must be the linkage I’m thinking. Thank you for everyone’s help

When I turn the key it moves out and then back in right away.

Tomorrow I’m going to do a bench test of the solenoid. Should be able to use a battery to test it from what I’ve seen. Any other ideas on how to test it? Just figure I should see the plunger go in and out with this test. Here’s the solenoid:

Do you disconnect at the injectors or at the pump?

It’s a repeat problem for me. I just started it no problem this morning, then went to start it 15 minutes later and nothing. I’ll try opening up the injectors and bleed at full throttle. The solenoid you guys talked about is that right by the Injector pump? Pretty big looking?

Thank you for the reply. The new pump sounds good and solid after a few seconds. I did have my wife crank the tractor while I bled at the injector pump. And it started right away thankfully. The info you shared is helpful for me in the future should I have repeat issues. Thanks!

Hi, I have a crank no start issue with my tractor. I’ve had issues with air in the system before when I’ve let it get too low on fuel. This time, full tank, went to start tractor and it only cranks. I replaced the fuel pump for good measure as it was older. Before I replaced it, I had my dad...

Thank you for that picture, I’m having a hard time getting measurements to match though. Here’s my bucket. It’s 33.25 inches from hook to hook. And 11.25 inches from middle of pin hole to top of hook notch. Seems to be closer to the SMS style. Thinking of having a bale spear made from scratch as...

Thanks all, I did purchase. It’s a BL20. It has a ballast box filled with concrete on the back. However the rear tires are not filled but I’m planning on doing that. 4x5 bales usually at our place. I wanted to see if you all knew the type of quick attach it has. Here’s a picture from the loader...

I need it to lift round bales and it seems like it should be fine. Hard to tell

Hi! Looking at buying a 2002 Branson 3520. It has a stock Branson loader on it but no identifying numbers on it. Any idea what loader came with these stock from the dealer? Thanks! Dan