Search results

The standards show 35mm as the width of that ball with a deviation of +0 and -2. I'll attach the hitch standards.

Lousy pic --- hopefully, this one is better.

OK --- I took that disk with the vent out of my cap. It looks like yours definitely has a pin hole in the center of that soft, flexible membrane that's dead center of the disk. Mine has no such pin hole --- it's a solid, soft flexible membrane. Maybe that's my problem ---- picture below without...

Whenever I loosen my fuel tank cap, the tank always seems to be under vacuum ---- is that normal?? I don't have any fuel supply issues --- it runs fine. With the tank under vacuum all the time, the plastic tank contracts/caves in a little. I already had one tank replaced because it developed a...

I just noticed a leak in my tank last week. Ultimately pulled the tank to find the location ---- I've attached a couple of pics that will help you visualize the location. It's on the side of the tank that faces the seat and at a molded corner. It's not a seam but rather a corner generated by the...

I just bought a little 3 point disc manufactured by Industrial Scientific Compnany, Fresno, Calif (Indusco). Long since gone out of business. It's an offset disc with six blades on each gang --- set up now to be about 57" wide but can be adjusted narrower. The name plate is nicely intact. It's a...

I've found various versions of the D950 engine --- DT,LA,A,B,FM,AT -- and I'm sure others that I can't recall at the minute. I've searched this forum and the internet for something that would explain the differences between the many versions of the D950 engine and can't find anything. Can...

Where's the least expensive place to get 12.4-16 R4 rear tires?

First things first; new member here and I do belive that I ought to say "Hello" before I get to any business. Just bought a 1994 or so B20 with 027 hours on the meter. It's at least 1,027 maybe more --- it's only a three digit meter. A B20 with FEL and TPH --- no backhoe although it does have...