Search results

I am replacing the seals on my Kubota BT600 dipper cylinder. I've only replaced seals on a couple of other cylinders and that was years ago. However I don't remember the other glands having this rough metal (right above the old rod seal). Is this normal? (mute it unless you want to hear my...

I am not sure what actually fixed it, in the end. Perhaps I just jiggled something that will rear its head again down the road. I traced the wires back to the firewall and then up into the dash. I followed them blindly, just by touch, and found that there was a loose connection to one of the...

No luck with the new key switch either. I am guessing wiring at this point - am I missing any other possibilities?

Thanks. I have one on order.

Thanks for that. I tested both of them, and they are fine - I wish I had done that to begin with.

Yeah, I am going to get some wire today to bench test with - will check both the old and new solenoid.

It has three wires. The only relay listed for my model is part of an alternator option that I don't have.

It happened after I had issues with the transmission safety switch sticking. At that point, it wouldn't start at all, but I got the switch cleaned, lubed, and working, but I now have the current issue.

I don't appear to have any voltage at the connector with the key in the on position. Need to find some jumper wires to test the solenoid.

Starts but as soon as the key is released she dies. The battery is fully charged. I've replaced the stop solenoid, but that didn't do anything. All the fuses are fine. No obvious wire issues. What else should I check/test before throwing a new ignition switch at it?

Attached the mower to the tractor last weekend, thought the pto collar locked on but about 10 minutes later the shaft came off the tractor. Looking at it then, two of the three ball bearings were stuck back inside. One of them I've freed but the other one just will not come forward. I can order...

I've had my bx22 since 03. Loved it for the little time I've actually put on it (360hrs). In that time I've never had any issues with it, but it has always lacked a bit in the muscle dept. Wondering if anybody has made a similar move and has feedback of any kind. The L2501 has a bit more...

My BX22 with 13 hours on it is suddenly losing power. Going up a small hill with only my rear mower attached and it will barely creep over the top and I get some black smoke as well (which stops as soon as I let off the pedal). Only did that twice before I shut her down. Checked a couple of...