Search results

I have searched on here and read quite a bit of info and yet i am still unsure. Can you use 3/8 steel line for the hydraulic lines on a cut? Thanks Crank

https://www.surpluscenter.com/item.asp?item=9-7816&catname=hydraulic This maybe a stupid question but i am trying to figure out what fittings are needed for this cylinder. It says SAE8 but i am looking at my gates hydraulic book and i show a SAE Male Oring,Male sae 45 degree flare swivel. I...

I am looking for a spool valve for my tractor that i am building. It will have a fel on it along with a three point on the rear. This is the valve i am looking at but i am a little concerned with the float feature on it. Do the valve only float with the lever in a certain position or does it...

QUick question. When using 2 cylinders to operate one device (fel loader) do you need to run a hydraulic divider to equal the lines when split or can you use just a regular tee? Same with the curl cylinders. i would think that if you dont regulate the flow to each one they could possibly apply...

As i have posted i am in the middle of building a tractor. I was planning on using a c4 auto but now i am starting to rethink it. I have a 4 speed amnual for it also. Looks like i am going to be adding a transfer case to it to get some better gearing. It will have a fel on it when it is done...

Well i have lurked here long enough with out posting anything so here it goes. I have always wanted to make a small tractor with a fel so after reading alot on here i have started. So far it encludes the following stuff. 2.3 l Ford from 88 ranger C4 from 81 mustang 9in rearend from an 79 ford...