Search results

Appreciate that. I didn’t know if there was a general thread size these machines used. I believe it’s the same thread as the two hydraulic blocks that are on the arms of the excavators are since that’s where the other end of the hose screws onto.

I appreciate all your replies. Is there any chance you know what fitting this is and where I can get one? It’s off a Lanty tilt bucket it came with two fittings and one is missing. I’m striking out at all local hydraulic outfits. It screws into the cylinder on the bucket and then the other end...

Thanks! Care to share how to adjust the main relief valve?

Thanks I’ll give it a shot tomorrow!

Thanks I’ll give it a shot tomorrow!

Thank you. I was hoping that’s all it took. I believe the ones I need to swap are right under the “floor board” I’m just unsure if it’s 2 lines or 4 lines I need to swap. I’m guessing 4. And also not sure if I can swap the lines on the top or bottom of the valve. Like I said, not an expert...

Hi all I came across this post recently after buying a diggit em15. I’ve tried reading through as much as I can to see if my question has been answered but I can’t seem to find it. I’m not an expert with these machines obviously, but I’m curious is there a way to basically make the joystick...