Search results

I have a 2017 CK 3510 SE HC I want to add an additional led rear work light. There is a wire harness and connector already there just below the windshield washer fluid container which is already hot. The connector is the same as the one on the wire harness located on the upper left part of the...

I am the new owner of a CK3510SE which replaced my 06 JD 2510. I got it half way through the February so not a lot of hours so far. I noticed that up where the smv is there is a wire and connector that must be pre wired for a some kind of emergency beacon. If the wire harness is there I would...

Went to use my tractor this morning the " joystick " was very stiff to move and the FEL would not raise up, hydraulic fluid appears to be ok in the sight glass. It was working fine when I parked the tractor the day before. The rear three point works fine as the snow blower would raise and lower...

I noticed a small drip of hydraulic fluid under my 2520 got underneath and just ahead of the drain plug near the mid pto there is a metal plate that covers part of the driveshaft where it looks like some kind of universal joint. There was a bit of fluid on the bottom of the frame where the plate...

There is a small spring on the hood latch of my 2520 and it must have broken and subsequently fallen off. I was wondering if a 2520 owner could do me a big favour and post a photo of the hood latch so that I could see where the spring is attached. Thanks very much

I have the older style of draft arms on my 2520 that rub on the tires and of course being a 2006 John Deere won't do anything for me. Always had a problem with the arms rubbing on the tires when the rear blower was attached. Actually read it on this forum last year where someone suggested using...

Just installed a rear led work light ( 24 watt ) on my 2520, works quite well.

I just purchased a LED worklight that I want to mount on my 2520 and was wondering what would be the easiest way to wire it in. Would it be ok to tap it into one of the tail lights or should it be separate. The light is 24 watts and draws about 2.5 amps. Any ideas would be appreciated.

I am about to change all the fluids on my 2520. The manual shows the transmission strainer which has a filter with magnets inside and held in with a spring. My question is when I remove the 4 cap screws and remove the cap will the spring come flying out. When I replace the filter and put the cap...

.I have a generic snow blower attached to my 2520. There are two problems one being an old issue of the draft arms on the 2520 rubbing on the tires. The second is that the spacing on the blower is wider than the arms. When I put torque on the blower the draft arms move and rub against the tire...

The front tires on my 2520 keep losing air so I want to take the wheels in and have them repaired. Where is the best place the jack to lift it up, and to place axle stands. Is is ok to lift under the front differential. I have the front loader installed and I would prefer not to have to take it...

I have a 2520 that is 3 years old with about 180 hrs. For some reason one of the connections came loose on the line from the loader to the tractor, got it reconnected finally after relieving the pressure now I noticed that there is a small drip off and on from one of the other connections think...