Search results

If you use a piece of cardboard. Place it above the respective part to make sure it is from there are above.

Cut a piece of 4 x 4 to support under the stump jumper. Apply penetrating oil to the bolt. Use a steel rod of your choice and a hand held sledge hammer and pound away. That is how mine came out. Didn't have to replace the bolts. Everything has been working for about 6 years. Nothing bent and...

Remove starter and use sand paper and sand the mating surface of the starter and mounting surface, for a good ground. Also while you have the starter out, see if it turns over OK with jumper cables.

It sounds like the chassis grounds are not good. We have a MF135 that will do the same thing. clean the grounds and it starts on its own with no booster pack. When you put on a booster pack you are just giving it a better ground.

If all the fires blowing east from the west coast. Then the people should be reimbursed for putting up with their pollution. All the trees that were lost, were helping with the air pollution. So removing trees by, fires, clearing ground for new construction, and so. The spaces that have vacant...

I have used the HF set to do 1/2" black iron for natural gas pipe. Made about 20 threaded joints and also other jobs. Held pipe with a 24" pipe wrench on the floor with plenty of cutting oil. to this day there are no gas leaks.

When tractor is running the charge light is on dim. With engine at mid range voltage at battery is at 14 volts. Every now and then battery is dead and have to jump to start. Replaced battery and voltage regulator and the light stays on dim. Pink wire from ign switch to starter went bad about two...

Fuel tank full, fuel gauge reads 0. Fuel gauge reads full if you put the 2 wires together at sender. Then gauge will read fuel until you start engine, rev it up and down a few times, then gauge reads 0. Have 6.5 volts at sender when reads full (not 12 volts) then reads 3.2 volts when gauges...

There is a hose that is connected to the top of the valve cover towards the rear of the engine. After the tractor has been run for a while and shut off. Anti-freeze will drip a few drops from this hose onto the ground. The tractor has a little over 1400 hours with no loss of engine power or any...

Plowing snow today the tach stopped working. Does anyone know if this is an electrical or mechanical type? If it is an electrical type where would the sending unit be at and how would you go about checking the gauge out. All I can find as far as parts go is just the instrument panel as one. Can...