Search results

The old glow plugs were old a couple years old but I was hoping new ones would help. Same but i will do some more troubleshooting and make sure all of the connections around the glowplugs are clean so there getting the right amount of current. I just ordered a switch, i like that idea and its...

Thanks, to clarify my starting system does work good. I am planning on replacing the battery as it’s getting towards 5 years old. I replaced the starter solenoid a while back and the ignition switch is new, have changed a couple. It turns over pretty strong, its like the glow plugs just aren’t...

Thanks for the write up. I am having a problem with my Tc29D now as well. I have been running the cheaper $18 timer for years now with no issue even in cold. This year I cannot get it to start without multiple attempts at heating and starting the plugs. I replaced the plugs and timer, still...

I have a cat 305 cr excavator with a Mitsubishi k4n engine, it needed a head gasket and head welded and decked. I need the torque spec but the cat dealer won't help me cause I haven't spent a million $ there. I have done research all week and this is what I found, can anyone confirm? I need...

Iv bee searching high and low for some online parts sources for this machine. Its a 2005. I just picked it up it has 5000 hours on it. At the very least a paper parts manual and shop manual. I know I need a front upper window. It needs some cleaning and work. It has an overheating issue but...

Heres a few pictures of the finished product, new paint, removed cab and engine door, powerwashed, wire-wheeld, sanded, primped and painted rebuild hyd cylinders replaced hyd lines new filters and fluid rewired back to factory schematic new tires machines ready to work. runs and work great...

Hello, I just bought a Mustang 920 (I believe) skid steer. It has a single cylinder for the bucket. I believe the 920 is the only model with 1 cylinder? If any one has any info on them year weight hp engine ect... It was repainted at some point and has no original markings i could see. It...

I have 30 acres I have a New holland tc29d that I use for everything. I get alot done with it but need something more. Im in the market for a mini excavator or dozzer. Will do mostly land clearing and road work. I have a swamp I would like to dig out as well. Tractor doesn't do well in mud. I...

I got a john deer 955, it has a yanmar diesel. It ran a 6+ months ago when it was parked, but now i cannot get it going to save my life. I get fuel to the injector pump but am not getting fuel to go threw the injectors. I cant understand how the pump could go bad form sitting, it did seem to...

I just got a lazer z with 350 hours on it, if you push both levers forward it will go to the left, the right side is faster then the left. seems like an adjustment, the last exmark zero i used did the same thing. from reading people are saying bad motor or pump, this thing has plenty of power...

I have a 2006 tc29d hydrostatic, it works fine, but i get a spun bearing high pitch sound from the transmission sometimes. I cannot figure out where exactly it comes from. It sound like A dry bearing if you blow it with compressed air, similar to cavitation in hyd system but its more of a...

IM buying a mx5100 this week and am thinking about remote hydraulics. How hard are they to install later? there expensive from kubota and i'm not going to need them right away. Eventually i want to put a grapple on top of my bucket and have hydraulics to run a splitter or our 8ft disk in the...