Search results

Model- YM2620D. Tractor fails to start. Cleaned all electrical connections. Battery checks out ok. Tried a new other battery. Same results. Pulled starter. Found starter filled with oil. Ykes!!! I thought that this area was to be oil free. Do I have a leak from the motor main drive shaft or a...

I have lost pressure to the rear 3 pt. and front Bush Hog loader. Hyd. fluid res. is up to fill mark. Bubbles on dip stick when I check fluid level. I looked for cracked lines on both the pressure side and on the return side. Found none. New Hyd. filter has less than 6 hours use. I cracked the...

I have unable to find the regulator on my tractor. The parts book has it 'free floating" on a block page. (part# 129350-77920 ?) It looks as if it should be mounted to the fire wall by the engine in the picture. I have nothing mounted on the fire wall. The battery is not recharging. I have...

I am trying to take some of the slop out of my steering (YM2620D). I have found the adjustment screw and lock nut on the right side of the steering box. I have been unable to loosen the lock nut. I have sprayed PB Blaster on the nut and adjusting screw. After several day of soaking, the nut will...

I am doing my winter maintenance on my tractor now. I noticed that under the housing that covers the wet brakes, there is a drain plug. If I remove this plug will hydraulic fluid drain out or special brake fluid? If it is hydraulic fluid, will the chambers refill from the master tank? Will the...

A few months ago I began looking to see if there was an attachment to mount on the rear of my tractor for cutting off small trees. I have a number of small size trees (4 to 8") to clear off my land to make new pasture. Last week I found a unique cutter (STUMPSTER.COM - TreeHog). It looks quite...

Has anyone tried mounting a sawblade on a brushhog? I was wondering if the back of the deck was removed, and a push arm was installed, could you slowly back into small trees (6" or less) and cut them off at or near ground level? I have a YM2620D. Is this enough power? I have seen rotory axes on...

The other day I tried to pick up a new fuel filter for my YM2620D. The men at my local NAPA store could not identify it in their picture/parts books. The filter is 3 1/2" tall, 1 3/8" wide, a 7/16" hole in the top is filled with a o-ring. Both the top and bottom of the paper element are metal...

I noticed that on the bottom of the wet brake housing there is a drain plug. When you drain your hydraulic fluid is the fluid pulled out of the wet brake case or do you have to drain each side seperatly? Much thanks, Dick

Does NAPA have filter cartridge to fit my filter assemble? Much thanks guys. Dick

I am about to change my hyd. fluid, but can not pin point the sump screen location. My YM260 manual showes the filter screen on the left side of the case. Not there. There is a three bolt cover under the rear pto to the lower rt. Is this it? Could it be under the return line fitting before the...