Search results

I bought a 8 foot grain drill, 12 tubes, and discs and there is no data plate or any other identification on it other than it's JD Greene, has yellow wheels, and big John Deere decals on front and rear. The attachment was modified somewhere in it's past life to be a 3 point attachment vice...

I picked up a 5 foot County Line tiller and when checking the oil in the gear box (attached to drive shaft) noticed it is extremely thick. The consistency is close to that of vasoline or corn syrup. The operators manual says it's supposed to use 120 weight oil. The tiller is probably 10 years...

I have a 2019 John Deere Gator XUV825MS4. This morning was out doing morning chores I heard some gurgling noise under the hood, but didn't think too much of it at the time. The engine temperate light never came on, so finished chores and parked it in the barn. Came back a couple of hours...

I am having a problem disengaging the MWFD on my John Deere 5065e. I know its not a good practice, but because of the muddy operating environment around here I leave the MWFD engaged most of the time. Today i was moving the tractor over to another area of our farm operation and moving on...

I have a new problem with my JD 950. It has a problem starting. It doesn't do anything on turning the key. It was working fine then suddenly wouldn't turn over. The engine red light comes on and I hear a faint single click when the range and gear shifters are in the neutral position. However...

OK, I finally got an iMatch quick hitch and thought I understood how to use it. I got it hooked up to the tractor and tried to hook up to my box blade. This was an epic failure. My tractor is a John Deere 5065e. I bought a Category 2 iMatch and planned on using my category 1 implements with it...

The subject sort of says it all. I have a JD 5065e tractor, which is a Cat 2. However, all my implements are Cat 1 left over from my old tractor. The old implements work on the new tractor, using the lift arm sleeve adaptor that slides over the lift pins. Will the Pat's Quick Hitch work with...

I have a 2013 John Deere 5065E with a John Deere 553 Front End loader. My question has to do with a recurring hydraulic leak in the "blue" line of my 553 front end loader. The first time a leak occurred was while using the loader to compress mud in my farm road after heavy rains. I was using...

I have been having one problem after the other with my Ford 2600. I posted last summer about problems with it starting then dying. I thought it might be the fuel pump, so I ordered one and it turned out to be the wrong part. I just cleaned out the old one really good and reinstalled it. It...

I had been having problems with my gas engine Ford 2600 cranking and then dying. I have a tractor mechanic from one of the local shops who is moonlighting on the side working on my tractor. His first thought was that the points were bad, so we replaced those along with the condensor. This...

DELETED

I am having problems with my John Deere 950 tractor. I was having problems with the tractor losing power and thought it may be the fuel filter. I changed the filter and bled the lines precisely in accordance with the operators manual. The tractor will start and idle, but when operated it...

I just got my dad's old JD 950 and after changing the battery it fired right up. I have a new problem now in that the PTO continues to run unless you hold the PTO selection lever to the rear. Is there a simple adjustment that can be made that will fix this? Thanks

Greetings to All This is my first post on TBN and have some questions related to an old rotary cutter. I have a 1981 model Ford 2600 tractor that came with an assortment of implements, one of which was what I assume to be an old Ford rotary cutter. It sort of looks like a Ford 951 and has...