ac

Does anybody know the belt size for the A/C? Mine broke today and the cab is like an oven without A/C. The part number is TA00047448A, but I don't have a dealer near me and I would like to just go to the autoparts store and pick up a belt so I can finish mowing. Thanks

while running my ac on low fan speed ac was working fine. the fan quit running no ac. I turned fan speed to 2&3 the fan started up but no cool air. I turned fan speed to 1 compressor kicks in but doesn't blow don't understand what is going on. any help will be appreciated

Recently purchased a 94' 3660, air blows but not cooling. Cleaned coils, Compressor is kicking in and cycles when temp. is adjusted. I am looking to check freon levels, but only finding 1 fitting on the back side of the Sanden compressor. Should there be 2 a high and low side if so where an I...

JD 7200, hot day, air conditioning did not work but oh well, husband is tough, going to pick some bales, Just down the road the tractor runs hot and leaks out all its oil. Investigate -> AC was seized, so serpentine belt burned through, whacked around and knocked out the engine shaft seal! So...

I’m going to replace the compressor on my Kubota L4200. I just learned that I can borrow the gauges at O’Reilly. Looks like I just bleed off the Freon to reduce the pressure in the lines. Then reduce the tension on the belt. Remove and replace the compressor. Recharge with Freon. I’m...

Initially thought it was belt and tightened it, but it didn't help. Sounds like clutch is not catching. Any pointers to fix and diagnose it myself much appreciated. Does not squeak with AC off

Hello folks, I’m helping a friend with his 5010HST. We’re not getting any power to the AC controls, or to the work light/ wiper switch panel on the right side of the cab. All the fuses check good, we have power on two different wires going into the relay box under the roof and no power coming...

1754 owner here, bought new in 2016. When new, the AC was really cold but lately it seems it's not as cold as when new. As a former truck mechanic, I recall that when drivers complained about their AC not being cold enough, one of the first places I checked was if the valve for the HEATER was...

I have a 2565 that I purchased in 2018. The ac has stopped blowing cold and it is absolutely miserable in the cab in this heat. I went to add some freon to it, but my gauge won't fit the ports. There are no threads on the outside of the fittings, just a radiused groove. From what I have been...