ball joint

My 5065e is 11 years old and these have cracked, likely dry rotted. I would like to replace them without removing the tie rod end. It looks like you can loosen the jam nut, then turn the flats on the opposite end, unthreading the shaft from the tie rod. When you do this , the joint must...

Hi there, Im trying to reseal the steering rack on a Massey 4245. Ive removed the rack, removed the RH inner ball joint with the outer attached to it. But struggling a bit with the LH side. The LH side seems to have a roll pin going through the joint and I cant see how to remove it. It feels...

I need to cut off and weld on new ball joints on the drag link for my 2004 Kubota B7510HSD. The drag link is the rod that goes from the steering gear box to the knuckle arm. Does anyone know where I can buy the correct ball joint ends or does anyone know the specs of them (taper, etc.) so that...