bolens

My little tractor is due for some regular service, in particular repacking the front hubs. These are a little different than I'm used to, they aren't tapered roller bearings, but open cartridge bearings with ball bearings. (they also have a castle nut with cotter pin) Do I still tighten things...

I have been thrilled with my bolens g274 TLB and recently found myself wanting to exchange my garbage craftsman riding mower for something by bolens. I am aware that anything built in the last two decades is junk, but how much further do I need to go back before they turned to garbage? I would...

I have the option to buy a 1668 hydro in non-running condition. The guy said all it needs is a starter motor gear, clean gas, and pump a tire up. Been sitting for 3 years and looks pretty rough. He wants $350. I don’t know exactly how I can confirm that’s all it needs, but if that’s the case...

Need instructions on wiring ignition diagram

Hi so I’ve been browsing the site and have found some information to guide me but I’m still not sure if what I gathered is good for my application. I have a bolens iseki h1502 and I am looking to install remote hydraulics to control a snowplow on the front. I am not sure where to plumb my...

Have a customer that has a Bolens tractor G274 and looking for an owners/service manual for it. Any help would be appreciated. Thank you May have other questions in the near future.

HI, need to replace the rear tires. I found a 29x10x15, kinda hybrid turf/ag tire. Could I use these tires? Thanks

I've got a lovely 1990 Bolens G174 / Iseki TX2160F tractor that has been well taken care of. I would like to continue that tradition. I've already got the basic operators manual but I don't have a real service manual nor do I have the experience to just ' know ' things (this tractor is older...

My G154/TX2140F is grinding gears when I need to change gears. Same thing when changing from high to low on the transmission. I can quickly change gears from one to another, but beyond that, I shut down the engine when shifting. I adjusted the pedal travel with no change and am thinking I...

I'm about to embark on trouble shooting what I think is my clutch since it doesn't seem to engage much and then only in low gear. Anyone have any tips on what to look for or where to best get a replacement clutch before I split it open?

This popped up on marketplace daily pics, after a few messages, I put in for a PA day from work and off we went on a 9 hour round trip drive up near Flint, Michigan. Super clean G174, only issue beyond dry cracked tires is the VR isnt work and it pushes near 17 volts unless you leave the lights...

I have a used Bolens 1308 PTO that I would like to sell. New bearings, new belts and new unused rubber coupling. Also includes the lever and cable to operate it. Would like $250. Shipping would be extra. Phone 360-520-3808, call or text.