cub cadet 1641

Gentlemen - I just inherited an old good shape 1641. The only problem is that it has been sitting for a while under cover and I would like to bring it about 1/4 mile from where it is located to my pole barn. It is a hydrostatic drive and I want to get it to my house to bring it back to life. My...

Help! My 1641 decided to quit running while it was working yesterday. There's no spark that I can see one with the old screwdriver trick, and nothing happens when I give it a shot of starter fluid while cranking. All other electricals are normal, lights, instrument panel, etc. It cranks over...

I have a leaking seal around main drive shaft that comes out front of my 1641 Cub cadet Lawn Tractor. How much trouble to replace seal, just pull the shiv off front and pull seal from outside, or is it more involved?

I can run my cub cadet for a lengthy period of time without any problems as long as the mower deck isn't in operation. When I turn the mower on, the battery begins to run down. I have serveral suggestions as to what the problem is, but no two are the same. Any ideas?

Hi, I'm new to forum. Have a Cub Cadet Model 1641 w/48" deck and snowblade. Was looking for a place with tips to keep the old girl running. Just had to replace the electric PTO (bearing seized). This is 2nd replacement since mid 90's. Normal failure rate? Also, it has never seemed to have an...

In a previous thread I was looking at buying a John deere 185 hydro,today found a very clean older model(1996) cub cadet 1641 hydro,briggs vangaurd 16 hp engine,with 350 hours in great shape so I bought it.Any thought or tips on the Cub cadet?Thanks for any information,coobie.

Anyone have anything good or bad to say about the mid 90's Cub Cadet 1641? Are these MTD mowers ? are they capable of handling any attachments?

Does anyone know what the ac voltage should be on the voltage regulator ? I am getting 16 at idle, haven't checked it at max speed. Also, just bought a new PTO clutch. Why does it turn so hard, you can barely turn it by hand. Doesn't this rob a lot of engine power ? The air gap is correct -...