ford 1110

My Ford 1110 diesel will go into gear when clutch is depressed, but tractor will barely move when clutch is released. I have tried adjusting the clutch with the nut and screw, but nothing seems to work. It seems like the pressure plate may be stuck. I noticed that when I was plowing snow, when I...

After researching a lot, I couldn't find any info on if a freeze plug heater would work/fit on a Ford 1110. Now that I have one installed, I figured I would make a post so others searching can find the info. Messisks has both CNH industries, part # 86590117 & 86590273, listed as potential...

I need help on possible things to look at on a Ford 1110 that was running before an oil and hydraulic change but now will not start. Here is a little backstory and details: I just bought a 1985 Ford 1110 with the HST with 1083 hrs on it. It was running and decent but not great starting in the...

Hi guys, new user. I recently bought some land next to ours and it came with an old Ford 1110 2WD HST. It hadn't run in a couple of years but the previous owner said that it ran great before he parked it but he couldn't find the key. So, I replaced the ignition switch, installed a new...

What looks like a freeze plug started leaking bad. It's located at the top backside of the block and partially covered by the Bell Housing. Has anyone had experience removing / replacing it and do you have to split it to replace it. Thanks

Looking for rear finders and light assemblies for Ford 1110 tractor

dose anyone know if any of the smaller Newhollend loaders will fit my ford 1110

helping friend with tractor problem = no power to starter. Just replaced water pump in front so it hasn't run in a while. repaired broken black wire = now the heaters work, but no power to starter with ign. sw. to start position. jumping sol.= engine turned over. took starter out and had checked...

I totally don't need this tractor, but for some reason, I seem really attracted to it. It's a mid 1980's Ford 1110. This is the 2 cyl Shibura one. It has the hydrostatic trans, rear pto w/ 3 point hitch, a 48" deck and 700 hours on it. I went and saw it, runs smoothly and works as you'd...

Found an 84 Ford 1110 4x4 for $4300. Good deal or not? Has loader, 6 foot blade, pto with 1100 hours. Seems to be in good shape and runs well. Bucket operated a bit slow but it was very cold out and the machine hadn't been running long, is this normal or a potential problem? Anything particular...

Well its not a 1410 the guy looked again, found out what it really is today, its a ford 1110, the guy was close i wonder why NewHoland dealer coundn't find it either. Its 4wd, hardy loader, no power steering, he says the backhoe is a kubota? but i take that with a grain of salt. New turffs, rear...