ford 941

I can not find where to look for the timing marks so I can find 4deg before TDC. I found on the 600's none high crop there is a peep hole put I can not find a hole any where on mine.

I posted a previous question on this subject but I didn't know if this should go to the old one or not. I wanted to check if my hydraulic pump has a screen. It worked fine until I changed the fluid and now it's slow. I have a small plate under the transmission 5 bolts and if I removed it would...

My 3 point hitch worked fine but was slow in the winter, i had never changed the fluid before so I drained the old out. It looked pretty bad, actually syphoned out the old because I couldn't get the drain plug out, refilled it with TSC premium Trans-Hydraulic fluid. Now the 3 point hitch goes...

The tranny, hydraulics and rear-end have 3 drain plugs so 3 different compartments. I was thinking of using a trans-hydraulic fluid for the tranny and hydraulics, and I'm not sure about the rear-end. Also the drain plugs look like pipe plugs and have square ends on them. The one for the...

I have a Ford 941 60" rotary cutter serial#WM02653 I need to find replacement blades for it. The blades currently on it are 19" long 3" wide 3/8 thick with a 1 5/16 hole and 5 "drop I don't know if they are original or not. Part # BNB-8083 shows up and is unavailable as far as I can...