gravely

I have a dependable Gravely 260 Z XDZ zero turn. Fired up all OK a few days ago with new premium no methanol gas plus starTron. Used it, shut it off, then back on it later, all working ok. Today won't start; it's a dead unit except for the bright red light on the control panel. Nearly-new Batt...

Hi all, Would really appreciate some advice on an upcoming purchase. Context: My new property has about 2.5 acres to mow, with over a dozen large trees and a handful of other obstacles, so decided on getting my first ZT. Grass is mostly a slope, but next door neighbor uses a JD ZT and it...

Morning, all. My mother-in-law is in her 70s and is now trying to take care of their home/acreage after her husband's recent passing. They have a Gravely ZT1840 (Kohler SV540-0022 engine) and the muffler has left the chat.. I'm trying to find a replacement, because it sounds like the lawn-mower...

Has anyone here replaced the front spindle bushings Part No 8 in the attached parts diagram? Wondering how much trouble they’re going to give me coming out, and hoping I can dive the lower one out with a good sized drift. Looks like a poor design to me. No provisions for lubrication, and it...

I have been looking at upgrading my current mower for something with a little more comfort and power. I had a Gravely Pro-Turn 152 and it was a great mower but not quite big enough. When I bought it, I had every intention of buying the Gravely 460 but felt it was too big at the time. Well, years...

Hello to all the zero-turn professionals. I am going to upgrade from my Gravely Pro-Turn 152. It is a great mower but I want something a little bit bigger. I was almost dead set on a Gravely 560 but the dealer I went to has Toro as well. I have never sat on or drove one until yesterday. I...

I have a Gravely 526. It has a Kohler K181 engine. I need a crankshaft and a flywheel for it. If I can't find parts for it, does anyone make a repower kit for it. I have seen in years past that gravelymay? made a repower kit for gravelys. Thanks

Hello all, My zero-turn had a clogged carb due to me not cutting ethanol fuel off last year in the gas tank over winter. This is my fault and I learned a lesson. I pulled the carb off, cleaned it and put back on. It runs fine now but I have to cut the fuel off and run out of fuel everytime now...

Can anyone tell me why my Gravely 8122 only runs in one gear when in fast mode. Gearing seems to be bypassed.

I just pick up a Gravely snowblower that go's on the front of there tractors. The S/N is 05117661 this is a 4" wide snowblower. I would like to put this on the front of my 4-wheel drive mini tractor. I will be putting on the blower it's on 20hp motor to run it. My question is how fast do the...

The drive is a year and a half old and is a little rough, it was supposed to be 6" deep but at this point is only 2-4" in many parts. It is currently non spec ABC (N rock around here), we had always planned to top it with something a little nicer post construction. All of the contruction...

Greetings everyone from Athens, GA. Looking to get advice on what folks here think would be the ideal tractor for my needs. I'm going to post a similar thread in the larger forum area, but thought I'd start on the vintage tractor page as I own and like working on older things, and frankly...

Although I have a lot of work to do outside, I’m stuck inside and I’ve been thinking about two things that I read pretty regularly on this forum and others about outdoor equipment. One is that machinery built 30-40 years ago was much better and that manufacturers should return to that quality...