hinomoto c174

hello, i have a hinomoto c174 and I'm in search of a starter, glow plugs and instrument cluster with the wiring going from the instrument cluster to the main harness . any help would be appreciated

The speed of my tractor is now really slow. The 3rd gear speed is the same as the first when it was working well. Now the first and back gear are super slow, Does anyone has this kind of problem before ?

Hi all I can get a well priced C174 with FEL, has bucket, forks and slasher on rear, seller has told me the FEL goes up and down but is slow. Seller used it for mowing close too fences that big tractor was too difficult to use near it is said. If all else runs ok, is this likely to be a big...

And could scan me the page on the cylinder head bolt torque sequence and spec? Need to replace the head gasket. Also could use the valve lash spec if there is one. I assume the valve rockers have adjustable lash as I have not torn it down yet as I can atleast move it under its own power for the...

My Hinomoto C174 brake shaft seals are leaking, letting enter oil into the the drum, by reducing the brake force dramatically. I haven't found any detailed description about this solution, how it looks like, what type of seals are needed. Is anybody has experience in this brake system? What type...

Trying to get this thread in the right place. Sorry. I have noticed my lift pressure is slowly decreasing over time and getting weaker. I have changed the transmission fluid and spin on filter and it helped a bit but I feel it should be higher pressure, easier to raise implements. I looked...

On my Hinomoto C174 I have noticed the lift pressure just isn't what it used to be. Have changed filter, spin on type, and fluid and have no leaks. Does anyone know if there is an additional screen in this system and if so where might it be. I have searched what books I have and see pics and...

Old newbie needs your expertise. My Hinomoto C174 alternator light has been running dim for several years but now it just got brighter. I only have 12.34 volts at the battery when running at 1500 rpm. The tiny generator, I would presume, has two black then a connector changes them to blue...

Hello All! Thank you for letting me join your group. I am looking for replacement filters (air,oil,fuel and hydrolic) for my Hinomoto c174 tractor. Anyone have any cross refrence numbers for these filters at a regular auto parts store.....Thank you very,very much....Dean

I live in Australia I need a head gasket for my C174. Last year i had to get one made but they did not do a good job and it has gone again between 2 cylinders I would like to get a genuine one if possible Can anyone help? Thanks

I see locally a Hinomoto C-174 4wd, with 400 hours. (4 digit meter, so this appears accurate). It looks original with some fading and scratches but no rust etc. Sounds like new. The seller can add a Koyker loader. How much should this cost with loader? With only 18 inch rear tires it's not...

I'm a new student to the world of compact tractors. Is there a brake set for my Hinomoto C174 somewhere that I haven't found yet?

My C174 is struggling to climb mild gradients and even on flat ground will not drive forward when put in HIGH range. It has a HydraStatic gearbox with just 3 ranges, High, Medium and Low. Even in Low range with the 4 in one loader and a carry all tray on the back but with no other load it cannot...

Hello, I have a Hinomoto C174 an I am looking to see if anyone would know a crossover Massey or Allis model number. I need a few parts and am having a difficult time finding them. I did find one place that would sell me the ignition switch that I am looking for @ $150.00 - yea right:-( Thank...

I am looking to purchase a Hinomoto C174 with a Loader and a 4' Finish Mower and Tiller and was curious what people think of the Hinomoto Tractors. I currently have an Iseki TL2100F that I am selling because it is too big to mow my lawn with. I am thinking I can use this little tractor for a...

How similar is a C174 to a C144? Are they the same minus the wheel size and HP? Is either similar to a MF1010?