hinomoto e2304

Hi everyone. I'm looking for Hinomoto e2304 service and/or operating manual. Regards

Hi! I have a Hinomoto E2304. Can anyone tell me how to check and add hydraulic fluid to the hydraulic system please? My front loader on the tractor sprung a leak and now theres not enough fluid to barely raise it. Thank you!

Hi Everyone, I have a Hinomoto E2304 with agri tyres. can anyone advise me what turf tyres I can put on this tractor please?

I have just acquired a hinomoto tractor in a junk yard in outside Tokyo I plan on shipping it home to Africa the deal was good and he tractor looked great. Am new to the tractor industry I would like to know a few grey areas with the brand

I just bought a hinomoto e2304, can someone give me some more information concerning 1.type of engine oil 2.type of gear oil 3.how long to glow (before starting the engine)? the glow-led on the dashboard always stays ON (when turning key to left), is this normal ?

hi everybody

Hello guys,I'm from Europe and I have purchased recently a Hinomoto E2304 4WD. I'm really pleased so far with it. However, I have a problem with the engine oil quantity. I've read that it takes about 3.5 litres of oil, but I've put in it about 5 litres, barely showing on the dipstick. The sump...

I own a Hinomoto E2304, I cannot seem to be able figure out how to turn the PTO off. And by doing this would it fix the problem i'm having with box blade not going up and down? Any help would be much appreciated!

Looking for parts for a Hinomoto E2304. Any suggestions on places that carry these would be appreciated. More specifically, looking for fuel system parts: need injectors and seats, settling bowl, fuel filter and "o" ring.

Hi all, Our Hinimoto E2304 ran fine for several years. Recently I noticed that when I was mowing it tended to die, so I had to give an extra swing on the gas throttle to keep it running. I decided to check some maintenance points myself. I let the old oil out, changed the oil filter, looked at...

LOOKING FOR SHIFT LEVER ASSEMBLY. HALF SPHERE, MAYBE CALLED WOBBLER IS WORN AND PIN THAT HOLDS SHIFTER IN PLACE POPS OUT OF ALIGNMENT CAUSING PROBLEMS WHEN TRYING TO SHIFT GEARS. MAY TRY LONGER PIN OR SOMETHING ELSE IF I CANT FIND ANY PARTS. PIN SLIDES UP AND DOWN IN ELONGATED HOLES AND GEAR...

Wanted workshop manual for Hinomoto E2304

Hi everyone Just bought my first tractor, an E2304 with loader. Not a bad little tractor for running around on my smallholding. :thumbsup: I have a couple of questions for you all: 1. to the left of the seat there are three levers. I think I have figured which one is H/L ratio, but I...

How easy or not is it to change the out put shaft.My neighbor used the tractor and returned it with the shaft snapped off.Also what is the availability of a new or used shaft?

Looking for a little advice... I am looking at a Hinomoto E2304 and needed input since I know nothing about tractors whatsoever. The current owner says the tractor is a 1997 but my research says that they only made this model til 1992. The tractor seems to be in above average condition and has...

I need to replace the driver right side rear tie rod on my E2304. After separating the tie rod for the steering linkage, I didn't see a nut or any evidence that the tie rod itself was screwed onto the steering rod that runs to the front. Rather, it appears to be welded onto the rear end of the...

I've got a Hinomoto E2304 that needs a starter. It's a Hitachi starter. Was wondering if anyone knew if it crossed to any Nissan cars. I searched the web last night and it looks like an '84 Nissan Maxima used the same starter. Any thoughts? Thanks...

Hi Everybody First, I'd like to say thanks for all the info I have gotten so far about my Hinomoto. I was leaning towards a Kubota L2201 but after much deliberation I decided on the Hino (3600hrs with loader and tiller, plus power steering!!!) because I was getting so much more for the money...

fired up the tractor hooked up the mower,:rolleyes: one pass down the field,started bogging down shifted to lower gear got rrs up again ran into taller grass bogged again but it put out bunch blackish smoke and died . Didnt run out of gas ,it would not fire up again ,got my pick up pulled back...

Has any one had a problem with coolant loss from air in the radiator? Acts like blown head gasket,runs cool for about an hour,till most of coolant is blown out. Can see bubbles in over flow tank,no water in the oil,tried flush and bars leak no go.no external leaks. priced a head gasket...

Has anyone looked into putting ROPS on one of these. I assume AGCO has ROPS that will fit the Deutz Allis 5220 or the Massey Ferguson 1030. I wonder if they would even sell them to someone unless the dealer installed them. I would also like a rough idea of the price on these.

I am looking into purchasing a 2304 and wanted to hear opinions of other Hinomoto owners. I understand that it is very close to the MF 1030 and the DA 5220. Have you had any difficulties getting parts for the 2304 through Massey or Duetz Allis dealers for this model? Is the engine HP 23 or...