install

I have a Kubota L3800 with R4 tires that are filled. I need to remove the tire and wheel to install the spacers. Is this a DIY task? Can I do this myself? Looking for suggestions on handling the tire and wheel. I will jack and block the tractor itself. Concerned about getting wheel off and back...

I've had a few 5th wheel/gooseneck trucks, all used... I am looking at purchasing another F350, but the one I've found doesn't have a ball in the bed. Just need it for farm purposes, towing. Dump trailer, tractor, equipment on flatbed, etc. 2006 F350 Crew/diesel What is a reasonable cost to...

I greet everyone, I am asking for advice. How to properly install connecting rods and pistons on an engine tecumseh OV691AE. where should the arrows on the pistons and the marks on the connecting rods point? have I placed them correctly? on this picture thanks you

I want to install a radio in my Massey 4710. I have pulled the access plate for the radio but can not locate the antenna cable. Has anyone installed a radio and give me an idea of where to look.

I'm looking for ideas to attach a 3500 HF winch to my tractor (RK25). I was wanting to put it on the front but maybe it would be best on the back? I was thinking permanent on the front somewhere. Removable would be fine for the back. 3-point? Hitch receiver mount? What gauge of wire to bring...

Hello all, I recently purchased a JD #7 backhoe for my 770 tractor and in getting it set up I learned I need the rear hanger brackets for the backhoe’s crossbar. I have a lot of fabrication skills and resources so decided I’d make my own instead of dropping good money buying them. I’m hoping...

2 Weeks ago I picked up a Yanmar YM1510D. It runs great but the Bush Hog 1846QT loader was not installed because it was leaking. I install the loader and hook it up (how they told me). I have no hydraulic fluid making it to the loader. I add fluid, clean the strainer, unhook lines, and the whole...