international harvester 2444

I'm trying to restore a 1970 IH 2444. I've got the tractor running good, have replaced the hydrolic pump, the power steering works good but the 3 point doesn't lift. I've dismanteled the control valve, replaced all 'O' rings, cleaned and reassembled but still no luck. I've now got it back off...

I've almost completed a brake rebuild on my !H2444. All of the linkages on the left side were rusted away. They are fairly easy to fabricate. The right side casting was full of grease/oil. At first I thought it was due to a leaky seal but upon inspection I don't see any leakage. It is a mystery...

My used IH 2444 has 18.4-16.1 tires. The rims are 8 bolt with a 6 inch center. The bolt circle appears to be 8 inches. Are there any other rims available to fit this tractor?

I have an old IH 2444 that has not been ran in a couple of years. I would like to get it running before I try and sell it. What all should I do to it before I try and crank it? 1. Battery 2. Fuel Filter and Fuel 3. Carb Kit 4. Change oil Remember I would just like to get it running before i sell...

Recently bought this early 60ies IH 2444 and having a problem locating the HYD suction screen. The IH-201 manual hasn't been much help. The HYD filler plug is just to the right of the gear shift, and I believe the HYD fill level plug is on the L/H side of the engine just below the clutch pedal...

Hi all, I'm new to the tractor scene and I was looking at I&T repair manuals for my recently acquired Industrial 2444. Does anyone know the correct manual to get for this tractor? It has the gas (C153) engine and a FEL, along with the foot throttle. I don't have access to it now to get the...

Hi all, I recently picked up my first tractor, an IH 2444. Unfortunately, it was sitting for several years and the engine was locked up. After putting several weekends of work into it (rebuilt starter, valve job, carb rebuild, etc.), I now have it running well. However, I need to work on the...

We purchased 6.5 acres earlier this year in AR. We had planned to purchase a used tractor to help maintain the gravel driveway, dig pier holes for our planned cabin, move dirt when needed, help lift constuction materials and cut the small amout of hay and brush. This weekend my wifes...

I own an IH 2444 Tractor that has been giving me some problems with the Transmission. The Transmission has 4 forward and 1 reverse speed in two ranges, high and low. The low range works fine, however, when the high range is selected the lever jumps back into neutral. All speeds work in both...