john deere 2030

I am in process of replacing the clutch on a American made John Deere 2030 diesel with reverser. The problem I am having is finding the correct clutch kit for my particular tractor because there are multiple variations and every time I think I have the correct parts located I find them on a...

Have a 2030 stuck in low range. Can shift through speeds but can't shift to high, rev., or park. Now stuck, wont restart since not in park. Has a loader. Any way to bypass park so can restart and get Serviced.

I have a 1974 John Deere 2030 and have a question about removing and replacing the steel hydraulic lines that run from the transmission up to the pump and oil cooler. One of these steel lines developed a pin hole. Apparently the previous owner removed the spacer that keeps the 3 lines...

Hello everyone...first day here in the forum. I have a 1973 John Deere 2030 with diesel engine, 8 fwd 4 rev Hi/Lol transmission, and I'm looking for a wiring diagram for it. Does anyone have anything I could possibly download or look at? I have the OEM tech manual but it's not much help. Hoping...

JD2030 has pto clutch issues What is value of this tractor?

It appears I have what is to be a common problem on a early 70's 2030. - no hydraulics for loader, 3-point or power steering Changed and cleaned ALL filters, new front end hydraulic pump. PTO works My son and I don't have the resources to split the tractor to dive into it so I have a few...

i have just bought a J D 2030 been standing 5-6 years water entered engine through rotted exhaust need to remove head as engine is solid. still has original oil and anti freeze so not leaked below piston level.Would like to know if any pitfalls to watch out for when removingthe head .Engine type...

I lost all the hydraulics on my tractor. Rockshaft, loader, power steering, etc. Independent PTO still works. Do not have hi lo or reverser. Main pump not getting fluid from transmission pump. Replaced filter and cleaned screen. Screen was covered with the filter material that was coming out of...

I have a 73 model John Deere 2030 that has a high pitched ticking coming from top end.. I致e had a few different people tell me that it痴 fuel knock. Ok , I have put brand new OEM injectors in it.. didn稚 go away.. I have pulled the head and had it worked with new seals and everything.. still...

Have 2030 John Deere with mounted loader. Had leaking cylinder on loader and fluid became so low loader would not lift. Repaired cylinder, installed and system would not lift loader as air had gotten into system. John Deere does not have a bleeder value, manual says use system controls to bleed...

hi all, I have decided to join this forum to get more info on my tractors and there is some really sharp people on here so here goes. I'm having an hyd issue on my 2030, heres whats it doing and what i have done so far. This tractor does not have a loader on it, i only use it for raking...

Hello everyone-- I have lurked here for a bit and have found some great info on the tractors we have on our small Pa. farm. I am hoping I can get a few suggestions on this challenge.... We have recently purchases a John Deere 2030 to replace an old warhorse and monster Farmall 966. It has a...

Hello, I have a John Deere 2030 8 speed no reverser and no hi-lo, pto lever is between the shifters it has a 146 loader which is currently off the tractor. Here is my problem, when the tractor gets up to operating temp the only way the three point will raise or power steering will work is if you...

Hello all, It's a standard unit. gas, no high/low, no reverser, standard PTO. After 3-5 minutes of operation all hydraulics (3 pt., steering, loader) will chatter and move slowly if at all. I can turn off the tractor for less than 1 minute, restart and hydraulic function will return for...

The 3 point hook up has been gradually slower about raising.It had gotten to the point that you had to speed the engine quite abit to raise.Now tries to raise the mower deck but can't

I have a john deere 2030 with a front loader. This is the first spring I have been without my IH, that I used for Bush hogging. Should the front loader be removed to Bush hog (maybe a half hour or 45 min worth.) just wondered how hard it would be on the tractor to keep the front loader...

My 2030 had a lot of slop in the steering and with the help on this site I narrowed it down to the bell crank. It seems like this is an issue for quite a few 30 and 40 series tractors. Most guys would just live with it but I decided what the heck and try to fix it myself. It really wasnt that...

Recently had lift rebuilt by dealer as it had blown a seal and was struck in up position. Removed rock shaft housing and dealer completed rebuilt it. Now back on tractor and working but... while in use it sometimes creeps up. So when have lowered implement hold my hand on lift handle to keep it...

Recently my lift arms went to the full top position and would not come down. Removed rock shaft assembly (sets under seat on top of transmission/differential housing) and took to dealer to rebuilt it. Problem was re-installing. It can be done wrong. Installed it twice incorrectly, tearing up a...

my john deere 2030 hyd just stoped working, no power steering ,no pto ,no front end hyd, help

Im looking for a pair of wheel weights casting number t25341 that fit a JD 2030 16.9" industrial type rim. I prefer to pick them up myself in the Iowa or surrounding states area. I would be willing to have them shipped if seller was willing to work with me. Thanks

I have a John Deere 2030 gas with a 145 loader on it. I bought the tractor this summer not running, it needed quite a bit of work. Every time I fire it up it rattles when first started and under load with a low idle. It goes away when throttled up. Is this normal? I also have another issue, we...

I have a 1974(or so) John Deere 2030 tractor and last fall As I was using a pull behind brush hog, I lost the hydraulics on the remote cylinder on the brush hog. As I was bringing the tractor back to the barn I started to lose the hydraulics on the front end loader and the three point hitch. I...

jd2030mannheim poor lift and steering when cold after twenty minutes running hardly any lift or power steering. no hi-lo shifter or reveser on tractor. filters clean,oil filter relief good. need help!

Hello to all out their. A 1975 John Deere 2030 (401c) it's having hydraulic problems. The reservoir is in the front of the tractor is empty. The reservoir is above the front pump and feeds it. Should the reservoir be empty at all. It looks like there is hardly any fluid flowing into it in idle...

Any weak mechanical areas on this machine? What about power and traction as a loader tractor?

My JD 2030 starting stutting down under load. I thought it was a dirty fuel filter, so I changed it. After bleeding the air, it still will start, but a few secondss (sometimes a minute) and die. I have pulled it on the road to be sure that the air is all gone. I have also blown out the fuel...

hello all, I have broken the lever that raises and lowers the 3-point hitch arms. I was wandering if anyone on here has ever repaired one of those and if so what does it entail. It looks like I have to take a major plate off the top of the tractor (below the seat) to gain access, but before I...