john deere 5210

New to me 2000 JD 5210. Has 3300 hrs. This thing will start and run for about 30 seconds. Blows a puff of white smoke and will not re-start without the help of starter fluid in to the air intake. I have changed the fuel filter added seafoam. Any insight would be much appreciated.

John Deere 5210 I purchased this and changed the filter And topped off fluid. It first appeared to work fine and then the steering and lift arms would not function. Not familiar with hydraulics. Any thoughts. Thank you

After changing hydro. fluid and filter, 3 point & front bucket don’t want to lift and tractor will not move. Also get bubbles influid after trying!

I replaced the fuel shut off selnoid, then the fuel shut off relay, then the small square relays in front of the steering column, and still not working! The crazy thing is that it will start out of the blue and run fine,then go through 5 or 6 start cycles perfect, walk away and come back and...

I just bought a john deere 5210 with a 520 loader and I found a hydraulic leak at the lift arm on one side. How can I fix this? Is there any way to take it off and replace the seal? Thank you

The radio speakers are bout gone. How do you put new ones in? Do you take the top of the cab off or from the inside someway?

My steering gets hard after about 2 hours of use. I have been told my inside filter might need cleaned. Does any one know where this is located on this model.

how do I bleed the air out of fuel line on John Deer 5210 with no hand pump on the injector pump?

First many thanks to JJ and others for the great help on my JD 2440 hydraulic question. Unfortunately, the tractor sold before I could make an offer. Now, I'm looking at a John Deere 5210 4WD with a JD 541 loader. My question has to do with adding remotes. The tractor has two existing rear...

Hi, I have a John Deere 5210 that pops out of C range. I put a new shift fork in it due to wear and it is much better but still pops out on occasion. Is there anything other than the shift sleeve the for goes in that may be damaged? Any help would be appreciated. Thanks, Al

i have a 2000 model JD 5210. the lift arms are slow to raise and very weak. i have changed the filter and fluid, and cleaned the pickup screen. if you race the engine the arms will lift. with no implement attached they raise at a normal rate but you can stop them with your hand. what could the...

I have a John Deere 5210 with approx. 900 hours. The left brake is dragging and locks up the left rear wheel when the brake pedal is slightly depressed. Anyone run into this problem and what is the remedy? Would I be able to make the repair? And what do you believe would be the cost of the...