john deere 655

I’m looking for a CV joint for my 1986 John Deere 655 compact garden tractor, passenger side…

I have an 1987 655. Its in really good condition, Ive been using it to remove snow this winter. So far Ive been able to get it running by keeping it in my insulated and enclosed shop. I also installed a block heater last year to get it warmed up. Today I couldn't get it to run. I Let the block...

I have an old JD 655 tractor that i have been using to run a three point brush chipper off the rear PTO. Since I am out of the seat to use the chipper, I have been placing a block under the seat to depress the seat switch so that the PTO would stay engaged. I have always removed the block...

I have a Deere 655 with a factory SCV for a loader. I put a newer 200cx loader on it. It worked well at first, but over time it has developed and issue where when lowering the loader quickly something hydraulically locks up and the loader won't go down. If I lift the loader just a little bit...

HI all, I have a little 655 that recently developed a few problems. First is I need to replace the dash light sockets, they disintegrated. I have new ones (5) but have no idea what wires power what lights. Can someone hook me up with a wiring diagram? The other issues are the PTO stopped...

My neighbor asked me if regular hyd oil can be used in a hydrostatic trans such as the JD 655 has? I told him no that it needs to be low-viscosity oil even in mild Texas Winters. What the correct answer please? Thanks,Jim

Now that the weather has turned cold my 655 starter turn over very slow - as if the battery were dead. I have a new battery installed. Even turns over (or tries to turn over) with the a larger battery starter attached. I have replaced the starter, but still the same response. In the summer...

How do I tell if the fuel injectors are still good? My JD 655 either starts hard or won't start, and won't rev up when it does start. I replaced one fuel injector, and it did not help. Any ideas?

My 655 PTO magnet gradually stopped holding until it would no longer engage. I have seen 855 owners with the same issue. It appears to be the time delay control module (TDM) based on the testing I have done. Does this part commonly fail? I checked all connections and applied a jumper as an...

Hello all! I have a JD 655 compact. it is the 4x4 diesel. I inherited it a little over a year ago. It has around 1000hrs I believe. It has no power? When ever you put it under the least little load it tries to die and belches black smoke. When I first got it the air filter was very dirty. I...

Hi guys - I just bought a used JD 755 and I noticed that the power steering hoses should be replaced. Looking at the part diagram online, instead of buying the parts from JD I was hoping to buy the hose and fittings, so it would be cheaper and so I can replace others in the future. Can someone...

Hi to all and Merry Christmas. In my free time I enjoy tinkering with tractors mostly, and more than anything I like to buy ones which are rough and give them another shot at life. I came across this 655, which doesent look terrible, but is rough. Says it doesent run, just wanted to get some...

What is value of Jd 655 4x4 hydrostat with 980 hours

Hello All! After doing an oil change my 655 will slowly gain oil. The tractor runs great, no excessive smoke, great power, starts easily, but I have this issues that seems to be getting worse. The engine has ~1k hours. The dealer suspects it is the injector pump. They even gave me the name...

I was wondering if anyone would or could tell me the length on the dipstick from the bottom to where the collar hits the tube. I got a 655 from a friend and I am trying to get it straighten out. The bushing that goes into the tube is loose and I have no idea where to set it to get a accurate oil...

just got a john deere 655 tractor yesterday, what do you have to do to activted the glow puu

I am looking for an air cleaner for a JD 655 (Yanmar 3TN66 engine) - everything from the intake on. Any help in locating the whole or even part of the assembly would be greatly appreciated. Thanks, Rob.

Can someone show me a exploded view of the rotor in a jd 655 roto tiller.The repair manual sucks as it does not show where the oil seal is. thank you

There is a used JD 655 Tiller for sale at a local eqipment dealer, he is not a tractor dealer. Never used a 3 pt tiller either. It will be going on my 2520, know this is one of two that JD says I can use for my size tractor. Priced out a new 655 an the dealership wants 2898.00.He wants 2000.00...

Just picked a JD 655 at an auction runs 16 hp with 10 at the pto. Wondering what kind of attachments it will run and just how useful it will be. It was a great deal I couldn't pass up. Came with a 50" deck and does a great job cutting the grass. I want to get a little tiller and thought about a...

I have a nice John Deere 655. I know deere recommends a 50" Mid mount mower on this tractor. Does anyone know if a 60" unit can be installed on a 655?

I just started using my new JD655 tiller with my Jd2520 and it works great. I did have a rock get stuck twice and both times it shut off the tractor. The pto shaft came with a slip clutch so I was surprised it did not slip but just shut down the tractor. After checking other posts about the slip...

Hi , is someone know where to find the shop manual for rebuilding the hydro-static pump for a JD 655 . my tractor stop working after a weird noise , the level of hydrolic oil was low but when i fill it no oil is cumming from the drain where the oil heater is installed just under the pto. I'm...

Does anyone have this setup a JD2520 with a jd655 tiller. I am about to get the 655 and want to hear from some that have this setup so I will be sure this is the right setup or should I go with the jd647. I measured the rear R4's tread and it is 49 inches wide so the 647 should cove all but one...

I have 17acrces and I have two JD tractors 655 & 955 . Joined to just learn more about them and best maintenance & repair policies. I wanted to hear what other are doing for filter and oil choices and oil changes when number of hours is not high. look for to participating in the community...

any advice on a jd 655 looking at a 1987 machine asking 8000 has a loader

Looked at a 655 with a 70 loader on it today. Whats $5350 for it with almost 1200 hours and a new Howse 4' box blade. The loader seems to be in good shape, the bucket may have been replaced or at least the edge recently. A couple of things I could use some information on. In high range...

Been looking for a little while for an upgrade in tillers from a 48 in tiller too something a little bigger. Was darn near settled on the popular KK 60" tiller for price, gear driven and seemingly bulletproof design. THEN a JD 655 tiller with a whole whopping total of 3 hours on it has turned...

Are there any other sources other then JD for tiller tines? They want about $350 for a set. I don't know if is fair or if there are alternatives. Thanks Andy

I am looking at buying a JD 655 Crawler Loader and the bucket attachments are worn enough to cause small visible movement when using the bucket. I can't tell if it is the pins or the holes in the links/bucket that are worn. Can this be repaired if it is the mounting holes that are worn or do I...

please delete accidential double post

Hello, I have a john deere 655 with a bad engine. there is no compression. if it would fit, I had considered switching the engine to a yanmar out of a 755 becuase of the additional horsepower, instead of repairing my engine or replacing it with the same yanmar. Does anyone know if this will...

I've bought a used 655 the darn thing is extremely cold blooded. Does anyone else have problems like this? South Dakota is sometimes a bit cold but it sometimes takes 20 min. to get the thing going. Any thoughts? :cool:

Got a JD 655 with a KK finish mower. I'm in need of some front suit case weights and have got a couple of questions. 1. How much weight do I need? Will 5 41lbers work? 2. Does any own a 655 and is as cold blooded as mine? South Dakota is where I call home....AKA God's Country. :)

I run out of fuel with half a tank showing on gauge. Some time ago I checked the sender unit per repair manual and everthing checked okay. Put it back together and just been fueling up on a very regular basis (like 2 gal. at a time) ever since. I just looked at picture again of tank in manual...

I have a JD 655 and have found a 365 blade that came off a 650. This blade mounts under the body of the tractor, not just on the front. The owner can't find a S/N on the blade. Anyone have any thoughts about whether this would fit? Thanks in advance, sorry I can't be more specific.

I was talking to a JD dealer regarding the 655 Tiller and dealer sales staff advise that the 655 is discontined. I question this as it is still listed on JD's web site. Dealer states that the 647 is only available? Anyone know the status of the 655? Also, who is the mfg of the JD 655?

I'm looking for a factory hyd. kit for a John Deere 655 (compact). Kit is no longer available from John Deere.

What is a fair price for a JD655 1986 450 hrs., 2WD, has SCV option for hydraulics, 50" belly mower, 4 ft. bush hog, rear blade. Kept in garage. excellent condition...! I am looking to trade in and want to know what a fair value would be. Thanks...!

JD655 2WD w/Loader \"Bad Idea\"??? Would a JD655 2WD handle a Bucket loader or should I forget it and trade in for a 4WD. What Bucket loader fits the 655, series 60? I have all the hydraulics set up on the tractor. Where can I price a used bucket loader for a JD655?

I have a JD655 1986 with ~450 hrs. 2WD 50" belly mower. I am looking to trade it in on Kubota 4WD probally 7400 with a bucket loader. It has been kept in the garage. What is a fair trade in price $6-7k..?