kubota g6200

Is there a cheaper trans filter for the Kubota HH660-36060 ? it’s for a G6200 HST.

Hi Everyone, I recently got a running Kubota G6200H. I was going to put new filters and fluids in it, and my HST oil came out like like milkshake. My current plan is to run 2 gallons of fresh oil through it, drain it, and repeat 2-3 times to clean everything out. On the bottom side of the HST...

I recently bought a G6200 in excellent condition with the 48" mowing deck. I would really like to add a three point hitch with rear hydraulics, and possibly a plow or snowblower for the front. I would appreciate any leads, or advice on adapting/using aftermarket available parts-pieces to use...

Hi everyone! I just bought my 1st tractor, a Kubota G6200. It's in great condition, but I'll be looking to make some improvements to it to make it more versatile. I'll be poring over all the great info here on the forum. Tim

Hello all, I have an issue with my G6200 hst and need to load it on my trailer to get fixed. Is there a release valve somewhere for the hydro? I can't find anything anywhere. I do not want to winch it on my trailer without releasing that. Thank you for your help.

What's a good replacement battery for this tractor that fits? How many CCA do I need? Thanks.

Years ago I got one and intended to put it on a machine I was restoring. Thinking about selling it and a good shape RC44 deck. May also part out what I have. Is there still a strong interest in these mowers? 5 or so years ago it seemed pretty strong but I have not been active lately.

Updating my progress on getting my late fathers G6200 back in service. I now have the tractor running. I took off the mower deck and replaced the belt and freed up the belt tensioner. After reinstalling the mower deck I took it out to see if it was cutting even. The tractor now will not run...

Can anyone shed some light on how to change this belt out. Cant figure out how to take apart where engine and drive pump meet. :confused:

Hello....new here. I am having trouble getting the air out of the fuel system since replacing the in line fuel filter. I have noticed that the fuel filter is not full of fuel after turning the engine over, is it supposed to be? I have taken the fuel line off the upstream side of the...

My G6200 is acting strange. Neither the water temperature guage nor the cylinder pre-heat switch are working and both went on the fritz at the same time. Is this a switch problem or a fuse (s) problem? This is a really nice tractor and I want to get 'er fixed up. thanks all

looking for one or two used rear Kubota G6200H wheels 23 x 10.50-12

Hi Are there someone who has pictures / drawings on how/where to connect the hoses from the valve for controlling the hydraulic lift on the deck? I hope to get to make the hydraulic lift on my G5200, I therefore need to know how relatives hoses can be connected. So if anyone can help with...

Had a rotted front tire on my 6200, wondering how I can get the tire off to replace it. It has, so it appears, outside and inside bearings fitted over a shaft capped by a Castle nut. I need to remove the tire and it looks like I'd have to use an impact hammer pounding on the end of the shaft to...

what kind of tires, brand included, gives the best traction yet does not rip up turf for lawn mowing on hills? My tires are hard edged being old and slip pretty easy going uphill. Need a good tread design that won't cut up turf yet give maximum traction for general usage. thanks

The guide wheels and shafts on the RC48-G20 on my G1800 are completely shot, do to previous owner(s) lack of greasing them. One of the rubber wheels is chewed up too, since the pin holding it on came out while I was backing up and it ended up under the deck while the blades where spinning...

Well, I have looked and looked. Bought a G6200 today and can't even find the clutch. HELP. Is there any place on the internet that can show me a diagram? I'll be ordering a manual but am in a bind, NOW! Thanks to anyone with help!

hi, i just got a G6200 with a 48' mower. can't seem to find too many information for the tractor. i would mainly use it for mowing and hopefully find a good deal on a snowblower for the winter. a tiller would be great too. has anyone had any luck retrofitting a snowblower of another make to...

My mower has almost 1000 hours and it and looks like it has been to war & back, but it has been pretty faithful at getting my acreage mowed! Biggest problems have just been parts wearning out. The latest failure is the bolt into the turnbuckle that lifts the deck (hydro lift) broke. Well, I...

My mower has almost 1000 hours and it and looks like it has been to war & back, but it has been pretty faithful at getting my acreage mowed! Biggest problems have just been parts wearning out. The latest failure is the bolt into the turnbuckle that lifts the deck (hydro lift) broke. Well, I...

Hi everyone, I have an 88 G6200H that has 490 orig. hours, I've babied this thing and it has been well cared for! Runs and cuts and still looks like brand new. Never had one issue with it! Over the weekend I was mowing and It stopped going forward to back up and go around a tree and when I...

I have been shopping for a lawn tractor, and I have it narrowed down to Kubota G6200 for $1400 (asking) and a IH Cub Cadet 982 for $1000. The Kubota is in decent shape - the diesel runs well, the 40" (yes, 40") deck is heavy and solid. However, the fiberglass body has one long crack above the...

I JUST BOUGHT A KUBOTA G6200H WITH 580 HOURS ON IN AND AM HAVING ISSUES WITH THE DRIVE BELTS. I HAVE BURNED THROUGH 2 SETS AND UPON MY LAST INSPECTION NOTICED THE TENSIONER JUMPING AROUND ALOT. WOULD THIS BE THE CAUSE OF THE BELT WEAR? IF SO WHERE CAN I GET ONE? THANKS IN ADVANCE FOR YOUR HELP.

I do have some extra Kubota G Series parts. Deck parts. 321-452-3863

I got a G6200 with a house I recently purchased (to go with my BX-23) and snapped a mower belt on it. In trying to replace it, it seems there is a trick to putting the belt on... like you have to disassemble the drive system to feed the belt around the drive pully. Does anyone out there have...

Does anybody know where I can find a G6200H service manual? I will pay for it. Thanks, Justin

I have a g6200h model kubota. I have been very satisfied with this tractor, but I think I have hydraulic fluid entering my oil. I need a service manual to help me change the faulty seal, but cannot find one for a reasonable price. Does anyone know where I can get one cheap...or better...

Hi all - newbie here... Very nice forum! I have an '88 Kubota G6200H with only 525 hrs on it. Nice shape, excellent mechanically. My Dad was the original owner, always garaged and maintained. I hate to part with it, but I really need a tractor that can mulch. After hounding my local dealer...