kubota l275

Hey folks, I’m new to the forum and had a question. I just purchased an L275 4x4 with FEL no power steering!! I saw some older threads about retrofitting from manual to power or power assist but nothing recent. Can you help a brother out?

Hey folks, I am new to the forum and have a question. I just purchased a mid 80s Kubota L275 4x4 FEL 541 hours. Is there any aftermarket products out there for retrofitting a manual steering to power or power assist. I致e seen some threads but they are very old.

This is my first post. Looking at getting a new-to-me tractor. it's come down to a Kubota L275 and a Yanmar 2310. From what I've been reading, both are good tractors with decent parts support. I'd like some opinions. What I'd like to use it for: mowing, single bottom plow, disc, moving manure...

Hello all. I usually post over in NH but this is for a friend. He bought a nice-shape L275DT, no loader, 900 hours, sight unseen. Also bought a Bush Hog SQ160, almost new, from another dealer. The service mgr at the Kubota dealer who serviced the tractor and shipped it to him said the Squealer...

I just sold my little Kubota B6100D tractor and yesterday went to purchase a 1983 Kubota L275, which I'm super excited about (see picture). When I arrived, the guy selling it started the machine without any problem whatsoever. After it ran for about 45 seconds, I turned it off so we could chat...

I bought a Kubota L275 that had the front end loader attachment but it was not on the machine. I connected it using the hydraulics on the side of the seat. I am getting hydraulic fluid but it is not lifting. Can anyone tell me if I have the hydraulics hooked up in the right location or if it...

I plan to check out at a kubota L275DT tomorrow. The asking price is $3800. No FEL. Says it has a hydraulic 4 way blade, engine rebuilt 60 hrs ago, good transmission, clutch, and gauges. Does that seem reasonable? Any specific things to check for when I go look at it? Thanks.

I plan to check out at a Kubota L275DT tomorrow. The asking price is $3800. No FEL. Says it has a hydraulic 4 way blade, engine rebuilt 60 hrs ago, good transmission, clutch, and gauges. Does that seem reasonable? Any specific things to check for when I go look at it? Thanks.

New the forum and just purchased a kubota L275 DT which is 4WD and I would like to know if anyone has a parts,service manual that I can beg, borrow or buy for this model or a contact where i may be able to get one.Any help will be greatly appreciated tony2576

I went to jump my tractor with a dead battery and got the leads crossed. Almost immediately there was a puff of smoke coming from near the starter. Now nothing happens at all. No power anywhere when the jumpers are connected correctly. Is there a fuse able link somewhere or did I just fry every...

I was using a bush hog attached to my 1981 Kubota L275 tractor. I overloaded the bush hog, causing the tractor to stop. Now when I try to restart the tractor, I get nothing - it doesn't even try to crank. The battery charge lamp and the engine oil pressure lamp both light up, but nothing else...

Hello, I am new here. Just bought my first tractor, an L275DT. I am not very familiar operating a tractor, sometimes in the past I helped a friend making hay on an old MF tractor, nothing more. Bought the Kubota to mulch my horse paddock, it is relatively steep, up to 30%. Following problem...

JUst wanted to know if it is possible to add power steering to a 1985 L275 Kubota tractor?

I am looking for a hood for my L275 wondering what other models will fit. Form researching it looks like L235 and L245 will fit. I heard L185 will to not sure.

I JUST PICKED A 1884 L275 DT WITH A LOADER, 4WD. A FEW DAYS LATER BOUGHT A BT750 AUTO RETURN BACKHOE THAT COMES ON A B20. I FOUND A QUICK DISCONECT MOUNTING BRACKET AT A TRACTOR SALVAGE YARD, ITS ON THE WAY.MY LOADER IS POWERED OFF THE PRITORITY VALVE UNDER THE SEAT. MY QUESTION IS ,CAN I TEE...

... it is in decent shape ... but LOTS OF hours ... 500+ on a newer meter .. what is something like this worth? ... would I be better off with a later model one? anything to look-out for ? ...THX

For sale about an hour away,seller doesn't have a whole lot of info on it beyond the model and such. Tach works sometimes,so hours are unknown. What should I ask him,what are the trouble spots? Thanks.

I recently replace the dual clutch in the L275. To do this I had to remove the BF400 loader and disconnected the hydraulics as instructed. Fluids and filters were replace. I did not put the loader back on but was using a box drag on the 3 point for about a half hour when the hydraulics failed...

I would like to replace the seat for my Kubota L275DT 4WD and would appreciate recommendations of what and where to buy.

Last week, I was trying to figure out how to install the Kubota supplied ROPS on the old Kubota L275 we bought so the spouse would have her own tractor. Well, after searching the ENTIRE internet, I found a set of instructions for installing the ROPS. Drove tractor up on driveway and got it...

I picked up another Kubota over the weekend, to supplement my newer Kubota and backhoe, we bought my wife a used L275 for helping to clear our new land. The guy who sold it to us had a ROPS and seatbelt, but had never installed them. I've never seen how the "retro-fit" ROPS fits on the Kubota...

This is a tractor I started working on yesterday for a customer of mine. I'm replacing the clutch, I repacked all of the loader cylinders, will be replacing all of the hydraulic hoses, and putting new o-rings in the loader valve. It's getting a new seat, exhaust pipe, drag link and tie-rod...

Any problems I can easily check for?

Does anyone know what the torgue on a water pump for a Kubota L275 may be? This is one item that is not in my manual? Thanks for any help!

I have an L275 with a 3" hole in the side of the block (previous owner-induced). I've been planning on patching the block because the crank appears to be fine, but I recently found a L235 engine block that can be had for a good price and I want to know if it can be used, after a little work...

I am looking at a L275, 4 wd with loader later this week. I presently have a JD 770, 2 wd without a loader. Any words of advice or things to look for on the 275 ? Does it have power steering ? Pros & cons ??

My 4wd engages on my L275 but does not have any power. (If I roll the bucket to raise the front wheels off the ground they turn when 4wd is engage, but don't when its not). They really don't do much in action however. My buddy was using my tractor to plow snow up at his house today and stopped...

I have a 1983 L275DT which I am considering getting a front loader. I'll primarily use the loader for snow removal but will likely use it for landscaping and maintaining our property. I don't believe my Kubota has power steering. Is a front loader recommended for my Kubota? What model? I've...

Title says it all. Have a line on a front mount snow blower that was used on a Kubota L275. Am looking at the possible purchase of a Kubota like B2410, B3030, B7800, L2800 or L3240 and want to know if the blower might fit or if it will be too much jigging to make the sub-frame work. Appreciate...

i have a kubota L275, 3-cylinder engine. when i pour water into the radiator is goes to the oil pan. im really hoping it is only a head gasket problem. what do you guys think?

i have a kubota L275, 3-cylinder engine. when i pour water into the radiator is goes to the oil pan. im really hoping it is only a head gasket problem. what do you guys think?

Finished! All new fluids and filters, paint and wax, new plexi windows for the Sims cab, a few modifications and bathed every nut and bolt in WD40. Looking a whole lot nicer than when I drug it home. I'm actually looking forward to the first big snow to try it out. I added two LED...

I need some wisdom - I'm new to this stuff. My new to me L275 was bought for its front mounted snowblower and heated Sims cab. While going through doing a full service and check-out routine I found a broken turnbuckle that connected the left side arm of the 3 point hitch lift arm to a small...

After pushing snow with a Western Pro Plow and hassling the drifts I decided don't get mad, get even! Just bought this oldie with 1190 hrs. for $4k. Be great to hear any info on this setup from anyone with experience.

Just bought tractor with new rebuild of engine. It didn't seem to make this noise when test driven. Now it has a low rpm knock that seems to disappear at higher rpm. Tractor has good power and runs well. Is this a quirk of the L275 or have I got a bigger problem?:confused:

Hello all, I have the option of purchasing a tractor from a friend of my FIL. It is a mid-80s Kubota L275 2wd with gear tranny, regular tires, a front end loader. The tractor seems to be in good shape with right at 600 hours on it. It also comes with a 1 year old 5' bush hog. I can get all...

HELP! on L2202/L275 piston and ring size Having problems with my L2202 rebuild. Bearings and piston rod (new) fit perfectly, but the piston and rings are about 50 mm too small. The sleeves look original with no sign of being bored out. Kubota insists that they are providing the right parts...

Hello! I have an 84 L275 3 cly Diesel. It won't start. It ran when it was parked about 3-4 years ago. I drained the tank, replaced the fuel filter, but still nothing. When I crack the injection lines, I get nothing. When I remove the valve (forget the correct name) that the line threads into in...

Temp guage not working. Got the Temp sensor, and could not find where it goes. The manual does not say. Could someone tell me, in simple directions, where to find this sensor? thanks!

I have had my L275 for a year, and it always starts, and I haven't had any problems. I went to move it and when it started it was leaking hydraulic oil from the starter, a steady stream of it. I pulled the starter every thing looks ok, I took the tractor out to check the clutch, and forward and...

what is the size and thread spec on the drain plug, I want to replace it with a magnetic one like what I use on my cars (you would be shocked at how much metal I pick up!)

Thank you in advance for your help. I have a mid 80's L275 Kubota with about 900 hours. Recently I have noticed a slight oil leak on the front portion of the engine from what seems to be a failed head gasket. Are there oil lines in the head in front of the engine? Has anyone seen this...

Replaced pump - still no hydraulic for PS, lift, or Frt end loader. All fluid is returning to trans and flows out if plug is opened. Is this a relief valve problem or a priority flow valve problem - these parts are very expensive and don't want to replace both if not needed. Thanks

Hi, I just bought 17 acres of land (Florida), mostly wooded, with about 2 acres cleared. I am going to be doing some mowing, landscaping, land clearing, road maintenance, and all the other stuff that you would expect. The land is fairly hilly for Florida, so i think a 4wd tractor is in order...

I am looking for a hood for a L275. Any ideas where to start looking? I can be e-mailed at p38@fcs.net

I'm looking for a small tractor with a loader and box blade for landscaping work. I looked at an L-275 today that seems to run good but looks ugly and has a few hydraulic leaks. When it was first started it was slow to turn over and was billowing smoke out of the exhaust. It didn't smoke after...